TechniSat DigiCorder S2 manual Country setting, Antenna signals, Antenna configuration

(Fig. 5-2)

(Fig. 5-3)

(Fig. 5-4)

Country setting

>Use the arrow keys to select the country in which you are located.

The selection made here will result in the time zone being set, and will affect the sorting of the programme list. (Fig. 5-2)

>Confirm by pressing the green function key Accept to accept the selection, and to go to the selection of antenna signals.

Antenna signals

Here you must select how many antenna signals are connec- ted to the receiver.

>Use the arrow keys left/right to select whether5 you have connected one or two antenna signals. (Fig.5-3).

>Use the green function key Accept to confirm and accept the selection, and to go to the antenna configu- ration.

Antenna configuration

This step of the installation allows you to adjust the setting of your digital receiver to the configuration of your antenna.

>If you wish to accept the standard antenna configura- tion, press the green function key Accept. (Fig. 5-4)In this case proceed with the point “Software upda- te”.

>If the configuration of your reception installation does not conform to the standard setting, press the yellow function key Change.

>Now proceed to make the antenna settings for your installation, as described in more detail under Point 6.4.

>Press the red function key Back to return to the overview of the antenna configuration.

>Use the green function key Accept to confirm and accept the settings, and to go to the software update.

Software updating

When you have completed making the antenna settings, the digital receiver will check whether any new version of the soft- ware for the receiver is available via satellite. If a new version is available, you can perform an automatic software update.

16