JVC DR-MV1B MasterpageRight+, Do not place the unit, To mobile phone users, On placing the unit

Page 3

Filename [DR-MV1SEK_02Safety.fm]

 

 

DR-MV1SEK_00.book Page 3 Thursday, April 15, 2004 3:30 PM

Masterpage:Right+

 

 

 

SAFETY FIRST

EN 3

The STANDBY/ON 1 button does not completely shut off mains power from the unit, but switches operating current on and off. “`” shows electrical power standby and “!” shows ON.

When the equipment is installed in a cabinet or a shelf, make sure that it has sufficient space on all sides to allow for ventilation

(10 cm or more on both sides, on top and at the rear).

When discarding batteries, environmental problems must be considered and the local rules or laws governing the disposal of these batteries must be followed strictly.

Failure to heed the following precautions may result in damage to the unit, remote control or disc.

1.DO NOT place the unit —

in an environment prone to extreme temperatures or humidity.

in direct sunlight.

in a dusty environment.

in an environment where strong magnetic fields are generated.

on a surface that is unstable or subject to vibration.

2.DO NOT block the unit’s ventilation openings or holes.

(If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.)

3.DO NOT place heavy objects on the unit or remote control.

4.DO NOT place anything which might spill on top of the unit or remote control.

(If water or liquid is allowed to enter this equipment, fire or electric shock may be caused.)

5.DO NOT expose the apparatus to dripping or splashing.

6.DO NOT use this equipment in a bathroom or places with water. Also DO NOT place any containers filled with water or liquids (such as cosmetics or medicines, flower vases, potted plants, cups, etc.) on top of this unit.

7.DO NOT place any naked flame sources, such as lighted candles, on the apparatus.

8.AVOID violent shocks to the unit during transport.

MOISTURE CONDENSATION

Moisture in the air will condense on the unit when you move it from a cold place to a warm place, or under extremely humid conditions—just as water droplets form on the surface of a glass filled with cold liquid. In conditions where condensation may occur, disconnect the unit’s power plug from the wall and keep it disconnected for a few hours to let the moisture dry, then turn on the unit.

ATTENTION:

To mobile phone users:

Using a mobile phone in the vicinity of the unit may cause picture vibration on the TV screen or change the screen to a blue back display.

On placing the unit:

Some TVs or other appliances generate strong magnetic fields. Do not place such appliances on top of the unit as it may cause picture disturbance.

IMPORTANT

Connection to the mains supply in the United Kingdom. DO NOT cut off the mains plug from this equipment.

If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain a proper safety approved extension lead/adapter or consult your dealer.

In the unlikely event of the plug fuse failing be sure to replace the fuse only with an identical approved type, as originally fitted, and to replace the fuse cover. If the fuse fails again consult your nearest JVC dealer.

If nonetheless the mains plug is cut off remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not supplied fitted with a mains plug then follow the instructions given below:

DO NOT make any connection to the Larger Terminal coded E or Green.

The wires in the mains lead are coloured in accordance with the following code:

Blue to N (Neutral) or Black

Brown to L (Live) or Red

If these colours do not correspond with the terminal identifications of your plug, connect as follows:

Blue wire to terminal coded N (Neutral) or coloured Black. Brown wire to terminal coded L (Live) or coloured Red.

If in doubt — consult a competent electrician.

Page 3

April 15, 2004 11:27 am

Image 3
Contents DR-MV1S DR-MV1B MasterpageLeft0 Filename DR-MV1SEK02Safety.fmMains outlet April 15, 2004 1127 amTo mobile phone users MasterpageRight+Do not place the unit Do not block the unit’s ventilation openings or holesSome Do’s And Don’ts On The Safe Use Of Equipment Above ALLMasterpageLeft+ Operate the VCR deck while recording on the DVD deck Engage the DVD deck’s timer mode.  pgEngage the VCR deck’s timer mode.  pg Watch another programme while recording on the unitContents DVD-R About DiscsRecordable/playable Discs DVD-RAM DVD-RWDiscs For Playback Only Region NumberUnplayable Discs Recording Medium And Format File Structure Of DiscsDVD-RAM DVD Video Marks Recording side Maintenance of discsCare And Handling Of Discs Label sideFront View Filename DR-MV1SEK04Name.fmApril 15, 2004 319 pm Rear View C D EF GFront Display Panel On-Screen Display VCR deck On-Screen Display DVD deckHow To Use Remote ControlCheck Contents Basic Connection To connect to a TV with AV input connectorsWhen your TV’s Scart Connector acceptsBefore starting, make sure of the following Auto Set UpNumber Set Auto Channel Set/Auto Clock Set/Auto Guide ProgramSet/Auto Guide Program Number Set Preset DownloadCable  pg , the unit will automatically perform Preset Download instead of the Auto Set Up in on page 19. AfterResults Of Auto Set Up/Preset Download Appearing On The Front Display PanelLink Functions DVD Deck Only On-screen Language Set Menu/Audio/Subtitle Language Set DVD deck onlyEnter Deck Only Satellite Receiver Control Setting DVDInstalling Satellite Controller Setting Satellite Receiver’s Brand And ChannelBrand Name Code Letter Box Monitor Set DVD Deck OnlyPan&Scan/Letter Box Pan&ScanBasic Playback High-Speed Search Playback FeaturesSkip Search Resume FunctionStill Picture/Frame-By-Frame Playback Slow MotionSubtitle Selection Stop modeAngle Selection Checking The Time InformationPress Audio or w e to select Audio Language/Sound SelectionAudio Channel Selection Playback Control PBC FunctionPressing 2 or 6 allows you to locate the desired scenes Live Memory PlaybackTo Watch a Programme Previously Recorded While Recording Recording/playback Status DisplayRecording screen Overview Of Live Memory PlaybackDisplay During Live Memory Playback Buttons To Be Used During Live Memory Playback Basic Operation On The On-screen Bar Using The On-screen BarHow To Access The On-screen Bar Contents of the on-screen bar during playbackAudio CD/Video CD/SVCD/JPEG/MP3 Repeat PlaybackDuring playback DVD-RAM/RW/RTime Search Adjusting The Picture Quality Simulated Surround EffectPress Enter to clear 3D-ON from the screen While stopped Setting The Progressive Mode Programme PlaybackSelect The Switching Interval Of The Slide Show Random PlaybackPerform steps 1 To Set Parental Lock For The First Time To Change The SettingsParental Lock To Temporarily Release Parental LockRecording Mode Basic RecordingRecording Resume Function Watch Another Programme While Recording On The Unit Recording FeaturesInstant Timer Recording ITR Slide the TV/CABLE/SAT/DVD switch to TVRecording time Free Rate FunctionSelection Of The Audio Channel To Be Recorded On a Disc Disc spaceSatellite Receiver Users Timer ProgrammingVideo Plus+ Daily/Weekly RecordingManual Timer Programming Press PROG/CHECK to access the Programme Check screenPDC Recording On-Disc Timer Programming To Timer-record The Programme With The ProgrammedDisc How Discs Are Overwritten To cancel the programme When Programmes Overlap Each OtherCheck, Cancel And Change Programmes CancelAbout the Automatic Satellite Programme Recording Indicator on the front display panelCompact VHS Usable cassettes Full-Size VHSPlayback Features High-Speed Search Quick Rewind a LittleIndex Search VHS Progressive Scan Next Function MemoryManual Tracking Soundtrack SelectionVCR recording lamp lights off on the unit Basic Recording Recording FeaturesLoad a cassette with the record safety tab intact Accidental erasure preventionRecording S.T. Picture SystemTo Record Nicam Stereo and Bilingual Programmes PlaybackPanel. Press Cancel & and input a valid PlusCode number You can use the remote control to enter the PlusCode numberPress VCR Timer # to engage the unit’s timer mode. VCR timer lamp lights up on the unit and the DVD deck isApril 22, 2004 509 pm OffTo cancel a programme Press Cancel & to cancel a programme Press VCR Timer #Refer to steps 7 11 in Manual Timer Programming  pg Limitations of registration Library Database DVD NaviAbout registration of information About editing of programmesModify Index When you want the pluralPress 8 to cancel pause mode after pressing Navigation Scan For Beginnings Of ProgrammesProtect Title Modify Programme NameModify Category Delete ProgrammeTo modify the points Modify Play List InformationDelete Unwanted Part Of The Programme Create Play ListAdd Scenes To a Play List Move ScenesDelete Unwanted Part From Play List Play Back Play ListDelete Play List Delete Information Modify Library InformationScan For Programme From Library Register DiscOn completion of the playback of all the items Locating The Desired Group And TracksFor MP3 Playback For Jpeg PlaybackDubbing An Entire Cassette For DVD deckFor VCR deck Press VCR/DVD repeatedly so that the VCR lamp lights up on Locate the point from where you want to start dubbing, thenRecord Pause mode Prepare the VCR deck for dubbingPress and hold DUB for more than 2 seconds to start Dubbing An Entire DiscLoad a disc you want to dub Press DVD to select the dubbing directionPress and hold 9, then press 7 so that the VCR deck enters Dubbing a Part Of a Disc73 DUB MasterpageLeft+DV Dubbing DVD Deck Only Performing dubbing without using the DV Dubbing controllerEdit From a Camcorder When using your unit as the source player Compatible with the Y/C signal Output And L-1 Input SettingSelect Setting Regular video signals, set to VideoInput Setting Digital Audio DubbingExample Dubbing to an MD 3 or 4. The remote control is preset to send 3 code signals Remote Control FunctionsTV Multi-Brand Remote Control Remote control 1/2/3/4 Code SwitchingSatellite Receiver Multi-Brand Remote Control Slide the TV/CABLE/SAT/DVD switch to CABLE/SAT65, 67, 74, 86 Simple Connections Connecting To a Satellite ReceiverProgramme When you can’t switch the audio channel of a bilingualOthers  pg Mode Set DVD DeckFilename DR-MV1SEK10Subsidiary.fm Utility  pgDuring Power Save mode Power Save does not work whenThis function works only for the Nicam bilingual programme Lots of flat, same-coloured surfaces such as cartoons Auto Picture quality is adjusted automaticallyAccording to your preference. Normally select Auto Containing a lot of noiseAuto Channel Set Video Plus+ System SetupTuner Set Guide Program Number SetRepeat steps 4 9 as necessary Press SET UP to close the Confirmation screenManual Channel Set View the Confirmation screen. Scan Completed isSet Stations a Fine-Tuning Channels Already StoredDelete a Channel Change Station Channel PositionJust Clock function provides accurate time keeping through PDC signalScreen the default setting is OFF Clock SetFormat a DVD-RW Disc To be chosen when you want to record, erase, orFormat a Disc DVD Deck Only Format a DVD-RAM DiscFinalise a DVD-R/RW Disc Cancel The Finalisation Of a DVD-RW DiscAfter finalising For DVD-R/RW Video mode discs Finalise a Disc DVD Deck OnlyTo unlock tray Scan Mode SetTray Lock DVD Deck Only To lock trayGeneral Playback DVD DeckRecording DVD Deck TV is not set to the AV mode. Set the TV to the AV modePlayback VCR Deck Recording VCR DeckTimer Recording DVD Deck Timer Recording VCR DeckPower failure occurred Set date and time correctly.  pg For RF/AV/S-VIDEO connection Other ProblemsInitialising DVD Deck Only On-screen Message DVD Deck OnlyTimer recording has finished during Live Memory playback An invalid PlusCode number has been input.  pgDuring Live Memory playback, 8 has been pressed.  pg Refers to individual chapters included in a title Glossary ENDimensions WxHxD Power requirementPower consumption TemperatureLanguage Code List Country/Area Code List for Parental Lock DR-MV1SEK00.book Page 99 Thursday, April 15, 2004 330 PM Station Name TV Station And ID ListTV Station Channel Number Guide Delete Programme Recording Mode Recording Resume FunctionSetting The Progressive Mode 26 41, 51MasterpageRight0 Memo EN104April 23, 2004 1015 am Filename DR-MV1SEK12Cov4.fm