JVC DR-MV1B Basic Recording Recording Features, Load a cassette with the record safety tab intact

Press PR +/– repeatedly to select the desired channel.

Filename [DR-MV1SEK_07VCR Operation.fm]
DR-MV1SEK_00.book Page 54 Thursday, April 15, 2004 3:30 PM	Masterpage:Left+

54 EN OPERATIONS ON VCR DECK

Basic Recording Recording Features

●Turn on the unit.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

479

VCR/DVD				8 REC MODE PR +/–
VCR/DVD				SAT
	1	2	3
	4	5	6	0 – 9
CANCEL (&)	7	8	9
		0		DISPLAY
				4
8				9
REC MODE				7
AUDIO
				PR +/–
TV/VCR

1 Load a cassette with the record safety tab intact.

●The unit’s power comes on automatically and the counter is reset to 0:00:00.

2 Press VCR/DVD repeatedly so that the VCR lamp lights up on the unit.

●Turn on the unit.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

●Press VCR/DVD repeatedly so that the VCR lamp lights up on the unit.

Watch Another Programme While Recording On The Unit

While recording is going on, you can watch another programme on the TV by using the TV’s tuner.

NOTE:

It is required that the remote control is set to be able to operate the TV in advance. ( pg. 76)

1 During recording, press TV/VCR to select TV mode if your unit is connected to the TV via the RF connection.

●VCR mode is disengaged, then the VCR indicator lights off and “TV” appears on the front display panel.

VCR indicator lights off.

●The programme received on the TV’s tuner is displayed on the TV screen.

2 Slide the TV/CABLE/SAT/DVD switch to TV.

3

Accidental erasure prevention

To prevent accidental recording on a recorded cassette, remove its safety tab. To record on it later, cover the hole with adhesive tape.

3 Press PR +/– or the number keys to select the channel you wish to record.

4 Press REC MODE repeatedly to set the recording mode.

Elapsed Recording Time Indication

Record safety tab

5 Press 7 on the unit to start recording. Or press and hold 7 and press 4 on the remote control.

●The VCR recording lamp lights up on the unit.

●If “O.S.D.” is set to “ON” ( pg. 82), “MARK” blinks on the screen while an index code is being marked.

B.E.S.T. takes place at the beginning of both the first SP and the first LP recording after inserting the cassette. ( pg. 55)

If “DIRECT REC” is set to “ON”, the programme that appears on the TV screen will be recorded. ( pg. 81)

6 Press 9 to pause recording.

●You can select channel during the Record Pause mode.

●To resume recording, press 4.

7 Press 8 to stop recording.

●The VCR recording lamp lights off on the unit.

1 Press DISPLAY until a counter reading appears on the front display panel.

2 Press CANCEL (&) to reset the counter before starting recording or playback.

●The counter is reset to “0:00:00” and shows the exact elapsed time as the tape runs. You can check the exact time of a recording or playback.

Recording Resume Function

If there is a power outage during recording, Instant Timer Recording or timer recording ( pg. 54, 56, 57), the recording will resume automatically when power is restored to the unit unless the unit’s memory backup has expired.

Page 54

April 15, 2004 1:27 pm