JVC DR-MV1B manual Digital Audio Dubbing, Input Setting, Example Dubbing to an MD

Filename [DR-MV1SEK_09Editing.fm]
DR-MV1SEK_00.book Page 75 Thursday, April 15, 2004 3:30 PM	Masterpage:Right+

		EDITING EN 75
NOTES:		Digital Audio Dubbing
● If you have a satellite receiver or a decoder connected to the L-2 IN/
DECODER connector, be sure to set “L-2 SELECT” back to
appropriate mode after editing.	You can dub selected audio from a DVD or Audio CD disc to a
● If you are not connecting a satellite receiver or a decoder to the L-2	digital audio device.
IN/DECODER connector, leave “L-2 SELECT” set to “VIDEO”.
	However, it is not possible to dub copy-protected discs.
● When “L-2 SELECT” is set to “SAT VIDEO” and “SAT S-VIDEO”,
“SAT” appears on the TV screen or front display panel instead of
	● Turn on the TV and select the AV mode.
“L-2”.
	● Slide the TV/CABLE/SAT/DVD switch to DVD.
● If “L-1 OUTPUT” is set to “SCART S-VIDEO”, it is not possible to set
“L-2 SELECT” to “DECODER” or “SAT VIDEO”.	Example: Dubbing to an MD
● If “L-1 OUTPUT” is set to “SCART RGB”, it is not possible to set “L-2
SELECT” to “DECODER” or “SAT S-VIDEO”.
● If “L-1 OUTPUT” is set to “COMPONENT” and “L-2 SELECT” to “SAT		Recorder
VIDEO”, “SAT S-VIDEO” or “DECODER”, be sure to connect the L-1
IN/OUT connector with a TV.

F-1 Input Setting

Set “F-1 INPUT” to the appropriate mode depending on the connector (VIDEO or S-VIDEO) being used on the front panel.

1Perform steps 1 and 2 of “L-1 Output And L-1 Input Setting” ( pg. 74).

2Press rt to select “F-1 INPUT”, then press ENTER.

3Press rt to select the

appropriate setting, then press

ENTER.

4 Press SET UP to complete the setting.

Coaxial cable (not provided)

Digital audio device (MD deck, etc.)

Optical cable (not provided)

* The boldface settings below indicate the settings at your purchase.

8F-1 INPUT — VIDEO / S-VIDEO

VIDEO: When connecting an appliance to the VIDEO input connector, set to “VIDEO”.

S-VIDEO: When connecting an appliance to the S-VIDEO input connector, set to “S-VIDEO”.

DIGITAL AUDIO OUT (COAXIAL)

Player

2

Rear of unit

DIGITAL AUDIO OUT (OPTICAL)

Note for connection:

Remove the protection cap from the cable.

1 Connect the unit and a digital audio device using either an optional optical cable or an optional coaxial cable.

2Place a disc on the unit and load an MD on the connected digital audio device.

3Select the audio to be dubbed.

4Start playback slightly before the actual point from where you wish to start dubbing.

5Press 9 to pause playback.

6Select the input mode on the connected digital audio device.

7Press 4 to start playback on the unit.

8Start recording on the digital audio device.

9Stop recording on the digital audio device. Then press 8 to stop playback on the unit.

NOTE:

There may be a discrepancy of several seconds between where you intend editing to start, and where it actually starts.

Page 75

April 15, 2004 3:18 pm