JVC DR-MV1B manual When using your unit as the source player

Filename [DR-MV1SEK_09Editing.fm]
DR-MV1SEK_00.book Page 73 Thursday, April 15, 2004 3:30 PM	Masterpage:Right+

EDITING EN 73

	Edit To Or From Another Recorder	Slide the TV/CABLE/SAT/DVD switch to DVD.
		1 Connect the player’s 21-pin SCART connector to the unit’s 21-
You can use your unit as the source player or as the recording
		pin SCART connector as illustrated.
deck.
		A When using your unit as the source player:

NOTE:	— connect its L-1	IN/OUT connector to the recording deck.
When using another recorder as the recording deck, refer to its	B When using your unit as the recording deck:
instruction manual.	— connect its L-1	IN/OUT or L-2 IN/DECODER connector to
A When using your unit as the source player:	the source player.

			● If another recorder is compatible with the Y/C signal (DVD deck only):
			— when using your unit as the source player, set “L-1 OUTPUT” to
			“SCART S-VIDEO”. ( pg. 74)
TV receiver	Player	Your unit	— when using your unit as the recording deck, set “L-2 SELECT” to
			“S-VIDEO”. ( pg. 74)
	2		2 Press VCR/DVD repeatedly to select the recording deck.
			3 Press PR +/– to select “L-1” for the L-1 IN/OUT connector, or
			“L-2” for the L-2 IN/DECODER connector, depending on the
			connector being used when using this unit as the recording deck.
			For DVD deck

		21-pin SCART cable	● When using the L-1 IN/OUT connector, set “L-1 OUTPUT” to
		(provided)
			“VIDEO” or “S-VIDEO”. ( pg. 74)
21-pin SCART cable			● When using the L-2 IN/DECODER connector, set “L-2 SELECT” to
	(not provided)		“VIDEO” or “S-VIDEO”. ( pg. 74)
			4 Press REC MODE repeatedly to set the recording mode.
			5 Engage the Play mode of the source player.
		Another recorder	6 Engage the Record mode of the recording deck.
	Recorder		7 Stop recording on the recording deck, then stop playback on the
			source player.
B When using your unit as the recording deck:			NOTES:
			● All necessary cables can be obtained from your dealer.
			● For Y/C signal input/output, be sure to use a 21-pin SCART cable
TV receiver			that is compatible with the Y/C signal.
	Recorder	Your unit	● When you use this unit as the source player for editing, be sure to set
			“SUPERIMPOSE” or “O.S.D.” to “OFF” before starting. ( pg. 81, 82)
			● If you are using another recorder with S-Video and Audio output
			connectors, connect its S-Video and Audio output connectors to this
			unit’s S-VIDEO and AUDIO input connectors on the front panel.
			Then, set the unit’s input mode to “F-1” in step 3, and set “F-1 INPUT”
			to “S-VIDEO”. ( pg. 75) (DVD deck only)
		21-pin SCART cable
		(provided)
21-pin SCART cable
(not provided)
		Another recorder
	Player

Page 73

April 15, 2004 3:18 pm