JVC DR-MV1B manual When Programmes Overlap Each Other, Check, Cancel And Change Programmes

Filename [DR-MV1SEK_06DVD Operation2.fm]
DR-MV1SEK_00.book Page 49 Thursday, April 15, 2004 3:30 PM	Masterpage:Right+
	OPERATIONS ON DVD DECK EN 49

DVD TIMER (#)

VCR/DVD

CANCEL (&)

PROG/CHECK

			SAT
1	2	3	1
4	5	6
7	8	9
	0

When Programmes Overlap Each Other

If “PROGRAM OVERLAPPED” appears, you have another programme overlapping the programme you have just made. Confirm with the arrow on “OK”, then press PROG/CHECK. Programme Check screen appears and conflicting programmes will be highlighted in pink.

ENTER rtw e

Check, Cancel And Change Programmes

1 When the DVD timer lamp lights on the unit Press DVD TIMER (#), then press 1.

When “ ” lights on the front display panel and the DVD timer lamp also lights up on the unit.

Press 1.

When “SAT#” lights on the front display panel Press SAT# on the unit, then press 1.

When the DVD lamp does not light up on the unit

Press VCR/DVD repeatedly so that the DVD lamp lights up on the unit.

2 Press PROG/CHECK to access the Programme Check screen.

● To return to the previous screen after you check the programme, press PROG/CHECK again.

To cancel the programme Press rt to select a programme to be cancelled, then press

CANCEL (&).

3 Press rt to select the programme, then press ENTER. The programme screen appears.

4 Change the settings of the desired recording options as required.

●Refer to steps 5 – 10 in “Manual Timer Programming” ( pg. 46).

Example: Programme 3 (you have just made) and Programme 4 overlap each other.

1 Confirm the overlapping programmes. Overlapping programmes appear on the TV screen.

NOTE:

If you do not mind this overlap, press PROG/CHECK to finish the timer programme setting. The programme with the lower programme number will be recorded and the other one will not be recorded correctly. If no changes are made for approximately 1 minute, the unit will return to the normal screen.

2 Press rt to select the desired programme to be cancelled or changed.

To cancel the programme

Press CANCEL (&).

●“THE TIMER PROGRAMING SETTING WAS CANCELLED” appears on the TV screen for about 5 seconds, then the normal screen resumes.

To change the programme setting

Press ENTER, then go to step 3.

3 Change the programme setting.

●Refer to steps 5 – 10 in “Manual Timer Programming” ( pg. 46).

4 Press PROG/CHECK to check if the conflict has been settled. Programme check screen appears.

5 Engage the unit’s timer mode.

●Refer to step 6 in “Check, Cancel And Change Programmes” ( pg. 49).

NOTE:

When any overlaps remain after deletion and modification of programmes, Programme Check screen remains showing the conflicting programmes. In such a case, repeat the procedure above until the conflict is solved.

5 Press PROG/CHECK to complete timer correction. The previous screen resumes.

6 For VIDEO Plus+, Manual or On-Disc Timer Programming Press DVD TIMER (#).

For Automatic Satellite Programme Recording Press SAT# on the unit for 2 seconds or more.

●The DVD timer lamp also lights up on the unit and the VCR deck is automatically selected. When the VCR deck is in timer standby mode, the unit is automatically turned off.

Page 49

April 15, 2004 3:30 pm