JVC DR-MV1B manual To cancel a programme Press Cancel & to cancel a programme, Press VCR Timer #

Filename [DR-MV1SEK_07VCR Operation.fm]
DR-MV1SEK_00.book Page 58 Thursday, April 15, 2004 3:30 PM	Masterpage:Left+

58 EN OPERATIONS ON VCR DECK

When Programmes Overlap Each Other

VCR TIMER (#)				SAT
VCR/DVD	1	2	3	1
	4	5	6
CANCEL (&)	7	8	9
		0
PROG/CHECK
ENTER				rtw e

Check, cancel and change programmes

1 When the VCR timer lamp lights on the unit Press VCR TIMER (#), then press 1.

When the VCR lamp does not light up on the unit

Press VCR/DVD repeatedly so that the VCR lamp lights up on the unit.

2Press PROG/CHECK to access the

Programme Check screen.

To cancel a programme Press CANCEL (&) to cancel a programme.

3 Press rt to select the programme, then press ENTER. The programme screen appears.

4 Change the settings of the desired recording options as required.

● Refer to steps 7 – 11 in “Manual Timer Programming” ( pg. 57).

5 Press PROG/CHECK to complete timer correction. The previous screen resumes.

6Press VCR TIMER (#).

●The VCR timer lamp lights up on the unit and the DVD deck is automatically selected. When the DVD deck is in timer standby mode, the unit is automatically turned off.

If “PROGRAM OVERLAPPED” appears, you have another programme overlapping the programme you have just made. The Programme Check screen appears and conflicting programmes will start blinking.

Example: Programme 1 (you have just made) and Programme 4 overlap each other.

1Confirm the overlapping programmes. Overlapping programmes blink on the TV screen.

2Press rt to select the programme to modify, then press ENTER or e.

● You can only select one of the overlapping programmes.

NOTE:

If you do not mind this overlap, press PROG/CHECK to finish the timer programme setting. The programme with the lower programme number will be recorded and the other one will not be recorded correctly. If no changes are made for approximately 1 minute, the unit will return to the normal screen.

3 Press rt to select the desired programme to be cancelled or changed.

To cancel the programme

Press CANCEL (&).

●“PROGRAM COMPLETED” appears on the TV screen for about 5 seconds, then the normal screen resumes.

To change the programme setting

Press ENTER, then go to step 4.

4 Change the programme setting.

●Refer to steps 7 – 11 in “Manual Timer Programming” ( pg. 57).

5 Press PROG/CHECK to check if the conflict has been settled. Programme check screen appears.

●“PROGRAM COMPLETED” appears on the TV screen for about 5 seconds, then the normal screen resumes.

6Press VCR TIMER (#).

NOTE:

When any overlaps remain after deletion and modification of programmes, Programme Check screen remains showing the conflicting programmes. In such a case, repeat the procedure above until the conflict is solved.

Page 58

April 15, 2004 1:27 pm