JVC DR-MV1B manual Video Plus+ System Setup, Tuner Set, Guide Program Number Set, Auto Channel Set

Filename [DR-MV1SEK_10Subsidiary.fm]
DR-MV1SEK_00.book Page 83 Thursday, April 15, 2004 3:30 PM	Masterpage:Right+

SUBSIDIARY SETTINGS EN 83

VIDEO Plus+® System Setup

IMPORTANT:

Normally, Auto Set Up ( pg. 19), Preset Download ( pg. 20) or Auto Channel Set ( pg. 83) sets the Guide Program numbers automatically. You need to set the Guide Program numbers manually only in the following cases.

●When timer-programming with the VIDEO Plus+ system, the channel position, where the station you wish to record is received on your unit, is not selected,

OR

when you add a channel after Auto Set Up, Preset Download or Auto Channel Set has taken place,

—Set the Guide Program number for that station manually.

●When you wish to timer-record a satellite programme with the VIDEO Plus+ system,

—Set the Guide Program numbers for all satellite broadcasts received on your satellite receiver.

●Turn on the unit.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

Tuner Set

Your unit needs to memorise all necessary stations in channel positions in order to record TV programmes. Auto Channel Set automatically assigns all receivable stations in your area to call them up by using the PR +/– buttons without going through any vacant channels.

●Turn on the unit.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

VCR/DVD		SAT
1	2	3
4	5	6
7	8	9
	0

ENTER	rtw e
SET UP

Guide Program Number Set

1 Press SET UP to access the Main Menu screen.

2 Press w e to select “INITIAL SET UP”, then press ENTER.

3 Press w e to select “SAT/

GUIDE PR”, then press ENTER.

4 Press rt to select “GUIDE PROGRAMME”, then press

ENTER.

5 Press rt to select the Guide Program number for the desired station as shown in the TV listings. Then press ENTER.

●To change the Guide Program number in 10 increments, press and hold rt.

6 Press rt to select “TV PROGRAMME”, then press ENTER.

7 Press rt to select the number of the unit’s channel position on which the Guide Program number’s broadcast is received by the unit or the satellite receiver. Then press ENTER.

●Pressing AUX changes “TV PROGRAMME” to “SAT”.

●To timer-record a satellite programme with the VIDEO Plus+ system, you need to install a provided Satellite Controller and perform the procedure described in “Satellite Receiver Control Setting (DVD Deck Only)” ( pg. 23).

●Repeat steps 4 and 7 as necessary.

8 Press SET UP to complete the setting.

Guide Program Number

“Guide Program (GUIDE PROGRAMME) number” refers to the assigned TV station numbers, according to broadcast area, for the VIDEO Plus+ timer recording. The Guide Program numbers can be found in most TV listings.

IMPORTANT:

Perform the following steps only if —

—Auto Channel Set has not been set correctly by Auto Set Up or by Preset Download. ( pg. 19, 20)

—you have moved to a different area or if a new station starts broadcasting in your area.

Auto Channel Set

1 Press SET UP to access the Main Menu screen.

2 Press w e to select “INITIAL SET UP”, then press ENTER. 3 Press w e to select “AUTO CH SET”, then press ENTER.

●When you have connected the unit

to a TV offering T-V Link via a fully-wired 21-pin SCART cable ( pg. 20), the unit automatically performs the Preset Download and the T-V LINK screen will

appear. ( pg. 20)

● The Auto Set screen appears, and remains on screen while the unit

searches for receivable stations.

Wait until the TV screen as shown in step 4 appears.

Page 83

April 15, 2004 3:21 pm