STB1000 Cabling Connections (Cont.)
1.Use one of the supplied
Note: Once the
2.Make the appropriate IR connection:
•If the LG display panel supports IR
•If the display panel does not support IR
The IR receiver should be installed in the IR bracket. When the IR bracket assembly is attached to the display, it should be mounted with
IR Receiver
IR Bracket
To IR RECEIVER IN
3.Use the supplied HDMI cable (with adapter, if necessary) to connect the DIGITAL VIDEO OUT connector on the STB1000 rear panel to the HDMI1/DVI input connector on the LG display panel.
4.Use the supplied Audio cable to connect the AUDIO OUT connector on the STB1000 rear panel to the RGB/DVI AUDIO input connector on the LG display panel.
5.Connect a 75 ohm coaxial wire from the Antenna/CATV wall jack to the ANT (Antenna In) jack on the STB1000 rear panel.
6.Plug the display panel AC power cord into the AC power outlet (AC OUT) provided on the STB1000 rear panel.
7.Plug the STB1000 AC power cord into a standard 120V 60 Hz power outlet. Once power is applied to the STB1000, the AC power outlet (AC OUT) is active. Also, the STATUS LED on the STB1000 front panel will begin blinking, indicating that the panel is in standby mode.
8.Use the supplied Installer Remote to turn ON the STB/display panel.
Note: It is recommended that you complete STB1000 Commercial Mode Setup and Cloning procedures before you make external equipment connections to the STB1000.
11 |