Reference: Upgrading STB Software using a USB Memory Device
Checking the Software Versions
Note: This function is not accessible while the TV is in FTG or PPV Mode.
You can check the software versions of the STB by accessing the Installer Menu with the Installer Remote: Press MENU repeatedly until the
LODGING PTC INSTALLER MENU
000 | INSTALLER SEQ | 000 |
| ||||
|
|
|
|
| |||
UPN |
| ASIC 20E7 | |||||
PTC | V1.00.00 | STB V3.00.00 | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Typical Installer Menu
PTC Version | CPU Version |
|
|
Upgrading TV/PTC Software
Before you begin, note that the software upgrade files must be stored in a folder named “LG_DTV” in the root directory of the USB memory device. Also, ensure the USB device has been formatted with FAT format.
Note for STB1000 Software Upgrade only: If the STB detects a later version of software on the USB device, it will automatically display a dialog from which you can start the software upgrade immediately. Otherwise, you can close the dialog and access the USB Download Menu as described below.
1.Turn ON the STB1000/display panel.
2.Plug the USB memory device into the USB port on the STB rear panel.
3.Press MENU on the Installer Remote to display the STB setup menus.
4.Use the arrow navigation keys to select/highlight either the Option (if EBL is in
5.Use the Up/Down arrow keys to select Upgrade TV Software or Upgrade PTC Software, as applicable, and then press ENTER. (See screen samples at right.)
6.Use the Up/Down arrow keys to select the upgrade to install, and then press ENTER.
Update completion progress will be displayed on the screen in a new window. Do NOT remove the USB device until the software upgrade is complete. When a software upgrade is complete, the STB will reset itself with an automatic restart. When a PTC upgrade is complete, the STB will turn OFF.
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV
i TV Software Update
[ Current TV Software Version Information ]
epak : 3.0b.0 | rootfs(RELEASE) : 0.00.1 |
model(RELEASE) : 3.12.0 | emanual(RELEASE) : 0.00.1 |
ezcal(RELEASE) : 3.0b.0 | kernel(RELEASE) : 3.12.0 |
lgfont(RELEASE) : 3.12.0 | micom(RELEASE) : 0.d0.b8 |
epak : 3.31.0 | lgapp(RELEASE) : 3.31.0 |
lgres(RELEASE) : 3.31.0 | model(RELEASE) : 3.31.0 |
ezcal(RELEASE) : 3.31.0 | boot(RELEASE) : 0.00.1 |
kernel(RELEASE) : 0.00.1 | rootfs(REA/LEASE) : 0.00.1 |
|
|
| |
|
|
i Upgrade PTC Software
The following software files are found in the memory card.
PTC_STB1000_v1.00.000
66 |