Cloning Procedures
Learning / Teaching a Master STB1000 Setup using a USB Memory Device
USB Cloning Notes
•Read the IMPORTANT CLONING INFORMATION on page 50 before beginning any cloning procedures.
•You may edit a filename as part of the Learning procedure; however, a file with edited contents will not be recognized.
•It is not possible to clone a Master STB1000’s clock using a USB memory device. Either set a Target STB’s clock manually, or use the Auto Clock setting in the STB setup menus.
Learn Setup from Master STB1000
1.Ensure the Master STB1000 is set up completely and the EBL is in
2.Plug the USB memory device into the USB port on the Master STB1000 rear panel.
3.Press MENU on the Installer Remote to display the STB setup menus, use the arrow navigation keys to select/highlight the Option menu icon, and then press the number “7” key a total of seven times to display the USB Download Menu.
4.To gain access to the “Learn From TV” option in the USB Download Menu, key in the password used to enter the Installer Menu (Example: Press
5.Use the Up/Down arrow keys to select Learn From TV, and then press ENTER.
6.To identify the profile from others, you can use the Up/Down arrow keys to change the last five digits of the filename. Press ENTER when you are ready to initiate Learning.
Learning status will be shown on the progress bar. When the Learning process is complete, the USB Download menu will reappear on screen.
7.Remove the USB memory device from the Master STB1000.
Teach Master STB1000 Setup to Target STB1000
1.Ensure the Target STB1000 EBL is in
2.Set Installer Menu item 117 FACT DEFAULT to 001, and press ENTER.
3.Plug the USB memory device with the Master STB1000 Setup file into the Target STB1000 USB port.
4.Press MENU on the Installer Remote to display the STB setup menus, use the arrow navigation keys to select/highlight the Option menu icon, and then press the number “7” key a total of seven times to display the USB Download Menu.
5.Use the Up/Down arrow keys to select Teach To TV, and then press ENTER.
6.Use the Up/Down arrow keys to select the Master STB1000 Setup you want to install, and then press ENTER. Note: Filenames identify the STB and the TLL version (see example at right).
Teaching status will be shown on the progress bar. When the Teaching process is complete, the USB Download menu will reappear on screen.
7.When Teaching is done, remove the USB memory device from the Target STB1000, turn OFF the STB, and unplug the STB power cord for 15 seconds.
8.Reconnect the STB power cord, and turn ON the STB/display panel. The Master STB1000 Setup should be resident on the Target STB1000.
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV
Learn From TV
Learn From TV
Select the file name and press OK to start
► |
|
|
|
► |
|
Previous | Enter |
!Learn From TV
UPGRADING...
25%
Do not unplug!
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV
Learn From TV
Teach To TV
Previous | Enter |
!Teach To TV
UPGRADING...
50%
Do not unplug!
51 |