LG Electronics manual Run Auto Tuning Channel Search, Verify the STB1000 setup

Commercial Mode Setup for Master STB1000 (Cont.)

(Continued from previous page)

3. Run Auto Tuning (Channel Search).

a)Search for all available analog and digital channels: Go to the Channel Menu, select the Auto Tuning option, and follow the on- screen instructions.

b)Use the Channel Edit option in the Channel Menu to edit the channel lineup, as necessary, to include free to guest channels only.

•Add/delete channels per your system requirements. Note that physical channel numbers are used to identify virtual channels. Also, channel numbers cannot be higher than 255.

•Use the Channel Label option in the Channel Menu to add familiar channel trademarks/logos such as ABC, CBS, NBC, etc. to the Channel-Time on-screen display. Identifiable labels (logos) should enable the end user to readily know what common networks are available. (You can add the channel labels in this step, or you can add channel logos or labels for channels without icons in step 5.)

4.Transfer the STB1000 Setup to the internal STB Controller (PTC): 2-5-5 + MENU Mode

After the STB channel lineup has been edited and channel labels added, enter the Installer Menu. Once in the Installer Menu, press

2-5-5+ MENU on the Installer Remote to initiate the transfer of the Master STB Setup to the PTC. The STB exits the Installer Menu and then tunes through the channels in the channel lineup during the transfer. When the transfer is complete, the STB tunes back to the channel that was tuned before the transfer began.

CHANNEL	Move	Enter
Auto Tuning
Manual Tuning
Channel Edit
Channel Label

Run Auto Tuning, edit channels, and select familiar channel trademarks/logos using Channel Menu options.

DIGITAL 19-3

MONO STEREO SAP

WXYZ

Custom Text Label “WXYZ” created in

2-5-4 + MENU (Add Channel Label) Mode.

Note: The maximum number of active channels that can be trans- ferred is 141. Total channels numbering more than 141 will result in erratic STB operation.

5.Add Custom Channel and Aux Source Labels for Analog Channels: 2-5-4 + MENU Mode

Enter the Installer Menu, and press 2-5-4+ MENU on the Installer Remote. Add/edit custom text labels to channel on-screen displays. Note that digital channels often have a broadcaster generated label (see 2-5-4 + MENU procedural information on page 49). When you are finished, press MENU to exit 2-5-4 + MENU Mode.

6.Verify the STB1000 setup.

At this point, verify that the channel lineup, channel icons, and custom labels are correct. Make sure the display features are set per your requirements.

7.Lock the channel lineup.

Enter the Installer Menu. Then, set item 028 CH. OVERIDE to 000 and press ENTER to lock the channel lineup and restrict access to the STB1000 setup menus. Press ENTER again to save your changes and exit the Installer Menu.*

The Master STB1000 Setup is now ready to be copied to a USB memory device or a clone programmer (see cloning information in this document).

028 CH. OVERIDE 000

After verifying the STB Setup, set Installer Menu item 028 CH. OVERIDE to 000.*

*This step prevents end users from accessing channel settings (i.e., the Channel Menu will be inaccessible/ grayed out).

206-4147 41