FTG Mode of Operation
FTG Configuration Overview
The following steps outline local FTG configuration of individual STB1000s. Since these models are equipped with the EBL module, they can also be broadcast configured in FTG Mode by a
Note: FTG Configuration Application software is available online at: www.LGcommercial.com/ FTGsoftware.
1.Install (if necessary) and launch the FTG Configuration Application (v5.0.0 or higher) on the PC that will be used to configure the EBL.
2.Build a Channel Map using the FTG Channel Map Editor in the FTG Channel Map Configuration Utility (or, if applicable, open an existing FTG Configuration (.rml) file).
3.Connect the PC to the
4.Turn ON the STB/display panel. Note: A green text banner that shows the EBL firmware version and release date will briefly appear on the display panel.
5.“Write” the FTG Channel Map to the EBL (converts EBL from
6.“Read” the current FTG Installer Menu settings from the EBL using the FTG Installer Menu Configuration Utility. If necessary to make changes to Installer Menu items, “Write” them back to the EBL in FTG Mode.
7.Save the FTG Channel Map and FTG Installer Menu settings to an FTG Configuration (.rml) file for future use.
8. Tune the STB1000 to a Logical Channel in the FTG Channel Map.
|
|
|
|
|
| |
|
| Use for local FTG |
|
| ||
|
| configuration. |
|
|
| |
|
|
|
|
| OPTICAL |
|
STB1000 |
| LAN |
| MPI/GAME | DIGITAL | SPEAKER |
| CONTROL | AUDIO OUT | ||||
|
|
| ||||
Jack Panel | DIGITAL VIDEO IN |
| CFG |
|
| OUT 8 |
|
|
|
|
| ||
2 |
| RESET | UPDATE |
|
| |
| .......... |
|
|
|
|
|
|
| RGB(PC) | AUDIO | DISPLAY CONTROL | REMOTE | |
| .......... |
| ||||
| RGBIN | (RGB/DVI) | ......... | CONTROL OUT | ||
| 1(DVI) | ..... |
|
Y PB PR L R
RJP | VIDEO | AUDIO | AVIN 1 |
COMPONENT IN |
| ||
INTERFACE |
|
|
Laptop
PC
58 |