LG Electronics STB1000 manual Editing/Adding Channel Icons and/or Labels

Adding Channel Label Icons / Custom Channel Labels (2-5-4 + MENU Mode)

Editing/Adding Channel Icons and/or Labels

If there is no pre-assigned icon, you can make a custom channel label of up to seven (7) characters to help identify a channel or network. If desired, channel labels can also be added in addition to a pre-assigned icon. You may also add labels for the Aux input sources to clearly identify the devices that are connected to the Aux inputs.

(Icon)

XYZ

XYZ XYZ

NETWORK

Editing and adding the labels can only be done if there are channels entered into the STB’s Channel Map either during Commercial Mode Setup (see pages 40 to 41), by cloning, or by using some PPV providers’ master remote controls.

Note: A blank letter space is available between “Z” and “!”.

To perform channel editing/labeling:

1.	Enter the STB Installer Menu: Press MENU repeatedly
	until the on-screen setup menus lock up, and then
	press 9-8-7-6+ ENTER.
2.	Press 2-5-4+ MENU on the Installer Remote to enter
	the Channel Label Editing Mode.
3.	Add channel icons and channel labels as described in
	the procedures below. (You can do this more than once.)

1 2 3 4 5 6 7

(Label)

4. To exit the menu when you are done, press MENU.

Changing a Channel’s Icon on the Master STB1000

1.Use Channel Up/Down to select the desired channel.

2.Use the Left/Right arrow keys to select the thin letter “I” on the Channel ID display.

3.Use the Up/Down arrow keys to select the icon with which you want to identify the channel. (If you know the icon number, enter the number, and press ENTER.)

4.Proceed to change/add channel labels, or go to the next channel.

Changing/Adding Channel Labels on the Master STB1000

1.Use Channel Up/Down to select the desired channel.

2.Press the Left or Right arrow repeatedly until the numbers 1 to 7 appear on the display. The number shows the position of the character that can be changed. Number 1 is the first character, number 2 the second character, etc.

3.Use the Up/Down arrow keys to select the desired character.

4.Proceed to the next number posi- tion, or use Channel Up/Down to go to the next channel.

Changing Source Labels on the Master STB1000

1.Press INPUT to select the desired Aux input source: A/V 1, A/V 2, HDMI Component, RGB, etc.

2.Press the Left or Right arrow repeatedly until the numbers 0 to 9 appear on the display. The number shows the position of the character that can be changed.

3.Use the Up/Down arrow keys to select the desired character.

4.Press INPUT for the next Aux source, or use Channel Up/Down to return to channels.

Installer Remote Control Key Functions for Master STB1000 Channel Editing/Labeling Menu

•Channel Up/Down: Tunes in the next channel in scan.

•Left/Right Arrows: Select the item to change. If “I” is shown, the icon can be changed. If a number is shown, it indicates the position of the character that can be changed.

•Up/Down Arrows: Select the icon or the character to be

displayed. Tip: Arrows can be held down for fast scrolling.

•0 – 9: Use to enter the index number of the icon, if known.

•ENTER: Changes the icon after the number has been entered.

•INPUT: Changes the Aux input label.

•MENU: Exits the editing process.

206-4147 49