JA Audio 9902S manual Installation of the Mediamaster, Preparing the remote control

Page 8

INSTALLATION OF THE MEDIAMASTER

The box for your Mediamaster should contain the following items:

• the Mediamaster
• remote control with 2 AAA batteries
• SCART cable (fully featured 1,0 metre)
• aerial/RF cable (double screened 1,5 metres)	RF cable
SCART cable	RF cable
• owner’s manual and software license agreement

Remote	Owner’s manual,
control	License agreement

About the SCART sockets
The rear panel of the Mediamaster is equipped with 2 SCART
sockets (see diagram). When you connect other products to any
of these sockets, always use fully featured SCART cables (as
supplied). There are “less well specified” SCART cables on the	SCART socket
market and picture quality could be reduced if you use them.	SCART socket

Preparing the remote control

•Remove the cover on the battery compartment at the bottom of the remote control.

•Insert the 2 AAA (1,5 V) batteries, as shown in the diagram, taking care to observe the + and - markings indicated inside.

•Replace the cover.

Connecting the Mediamaster to the dish

If you need to fit the F-connectors onto the cable

•Prepare each end of the cable as shown in the diagram. You will need to fold back the outer braid (as shown).

•Slide the F-connector onto the cable, then turn it clockwise until it grips the braid.

•Ensure that 3 mm of the core is protruding from the end of the connector.

Installing the satellite dish

•See the ”Fitting instructions for satellite dish” on how to in- stall the dish.

•Connect the coaxial cable, with F-connectors fitted, from the LNB on the satellite dish to the socket marked ”ANTENNA”on the rear panel of the Mediamaster.

GB 8

15 mm

8 mm

F-connector

3 mm

Image 8

Contents Mediamaster Page Contents Mediamaster 9902 SGeneral Information about the Mediamaster For Your SafetyImportant Information in the Event of Service + P Remote ControlPad Rear panel Front and Rear PanelFront panel Viaccess smartcard Only for services coded with the Viaccess CA systemAbout the Smartcard and CA Module CA module with its smartcardConnecting the Mediamaster to the dish Installation of the MediamasterPreparing the remote control Connecting to the TV Connecting a TV and VCRGeneral If your TV has a Scart socket, but your VCR does notConnecting to the built in phone modem Connecting an analogue satellite receiver and a VCRConnecting a HiFi system Tuning your TV to the Mediamaster Switching on for the first time with Scart connectionsTuning procedure when RF connections are used First Time Installation General informationWelcome menu LanguageAlternatives 1-6 requires the use of a Universal LNBs RF modulator typeAntenna/satellite selection Antenna adjustment and signal check Line 1 through 4 on the antenna satel- lite selection menuConnection of a two port DiSEqC switch Line 5 and 6 on the antenna satellite selection menuMultisatellite/mini DiSEqC One antenna/one LNB configurationLine 7 on the antenna satellite selection Menu Multisatellite/two port DiSEqC Connection of a four port DiSEqC switch Multisatellite/four port DiSEqCChannel search Automatic searchAdvanced search Motor antennaManual search Press OK Adjust motorType of motor First Time Installation Channel search progress Time adjustmentFinishing the first time installation Viewing Mode Programme informationI information button GuideList of TV and radio channels Options green buttonAudio language Subtitle languageTV release Text button teletextRecording on an external analogue Video recorder Recording from the hard disk to a video recorderHard Disk Recording About hard disk recordingLocked functions during recording Different ways of making recordingsRecording menu Pause Recording To watch the pause recordingTo finish this example of a pause recording Timer recording Normal recordingTo start playback of a recording Pause functionHandle Recording menu appears Pause during playback of a normal recordingWatch the playback at a different speed Fast Forward and Rewind of a pause recording in progressSlow Motion function Small steps during playbackFind a specific position within a playback Edit function Play List of recordingsHandle recording Rename EraseAdd another recording Recording informationSave a recording as Erasable or Permanent Main Menu TV and radio channelsEdit channels Important about editing channelsHow to give a specific name Create listRename list Rearrange listsRename channels Select channelsLock channels Rearrange channels Delete channelsRemove channels To remove channelsUpdate channels Update channels via a PCSystem configuration Edit satellitesTo add a new satellite For a fixed antennaWhen your antenna is controlled by a motor Antenna/Satellite configuration TV settingsModem Setting Receiver upgrade ReinstallErase hard disk Information about the modemLanguage preferences Parental controlAppearance preferences Recording preferences Make new recordingsSaved pause recordings Repeat playingErase before record hours Type of programmeReceiver number System informationFollowing extreme example System informationConditional Access Viaccess embeddedDiagnostics Release infoCommon Interface CI Smartcard settingsTimer Important information related to the timer recording Timer setupGlossary of Terms AGCProblem Solving Problem Possible causes What to doWhat to do if you can’t solve the problem Front Panel DisplayTechnical Specifications Security information0226