Avaya S8710 manual Connecting directly to the Ipsi

4Connecting to the IPSIs Programming the IPSI circuit packs

Figure 1: Connecting directly to the IPSI

CLK

1

2

3

cadlipsi KLC 031502

4

S E R V I C E

N

E

T

W

O R K

Figure notes
1	Services laptop	3	NIC adapter cable (if necessary)
2	PCMCIA Network Interface Card (NIC)	4	CAT5 crossover cable to IPSI

NOTE:

Make sure you have the password before proceeding.

1Connect the services laptop computer to the top port on the IPSI circuit pack faceplate.

2From the services laptop Start Menu, click Start > Run to open the Run dialog box.

3Type command and press Enter to open a MS-DOS Command Line window.

4Type arp -d 192.11.13.6 and press Enter to clear the ARP cache in the laptop. This command responds with one of the following:

•The command line prompt when the cache has been cleared.

•The phrase: The specified entry was not found. This is returned when the specified IP address does not currently contain an entry in the ARP cache.

5Type telnet 192.11.13.6 and press Enter to open the Telnet window and connect to the IPSI Prompt = [IPSI]:

NOTE:

While connected to the IPSI, type help or ? to obtain online help. Most commands have two or three letter abbreviations.

52	Installing and Configuring the Avaya S8700 or S8710 Media Server
	June 2004