Avaya S8710 manual Interpreting the test results

Testing the media server installation 7

LED indicators

Using the Maintenance Web Interface, test the LEDs on the front of the media server:

1Under Diagnostics, click Test Server LEDs.

2On the Test Server LEDs screen, click Test LEDs.

3Observe the Active/Standby and U2 LEDs on your media server and the transmit LED on your duplication card (back of media server) to ensure they are blinking.

Interpreting the test results

An abnormal condition is indicated if an LED shows any of the following flashing patterns.

•LED flashes red. This indicates that the green element is either burned out or not controlled.

•LED flashes green. This indicates that the red element is either burned out or not controlled.

•LED flashes between red and amber. This indicates that the red element is stuck on.

•LED flashes between green and amber. This indicates that the green element is stuck on.

•LED stays amber continuously. This indicates that either the media server is hung or the LED controller is stuck.

•LED stays off continuously. This indicates that the media server is hung or powered off, the controller is stuck, or the media server is using a new or different LED controller.

If the media server is hung, you do not need to do anything. It should automatically reboot and fix itself. If the media server does not reboot itself, power it down and then reboot it.

If an LED is clearly stuck or has a burned out element, ignore the indicators until you can conveniently replace the media server.

LEDs on the back of the media server

There are two sets of LEDs on the back of the media server: one set for the 4-port NIC card and one set for the fiber optic cable used for memory shadowing. The GREEN LEDs to the right of the NIC ports light up when they are in use. The GREEN LEDs to the right of the fiber optic cable indicate that the cables are connected correctly.

Installing and Configuring the Avaya S8700 or S8710 Media Server	73
June 2004