Avaya S8710 manual Verifying that IPSIs are translated

4Connecting to the IPSIs Verifying that IPSIs are translated

16Type quit to logoff the IPSI.

NOTE:

Control network settings (IP address, subnet mask, and gateway) become effective when you exit the IPADMIN session.

17Check the LCD. Verify that it has an I P with a filled-in V showing at the bottom. (See Figure 2, LED display showing that the IPSI has a static IP address, on page 54)

Figure 2: LED display showing that the IPSI has a static IP address

CLK

S

E

R

V

fpdlled1 LJK 022502

18Disconnect the laptop from the faceplate.

NOTE:

Always use the arp -d 192.11.13.6 command (step 4) to clear the ARP cache on the laptop before connecting to another IPSI. If the cache is not cleared the laptop appears to hang and does not connect to the next IPSI.

19Repeat for each IPSI circuit pack.

Verifying that IPSIs are translated

NOTE:

You must be on the active media server to use SAT commands.

1Type list ipserver-interface and press Enter.

2Verify that all ISPI circuit packs are translated.

54	Installing and Configuring the Avaya S8700 or S8710 Media Server
	June 2004