Avaya S8710 manual Testing the media server installation, Testing the TN2312BP Ipsi circuit pack

Testing the media server installation 7

Testing the TN2312BP IPSI circuit pack

7 Testing the media server installation

This chapter provides tests for the control network, including

•reviewing the status of the configuration.

•testing the IPSI circuit packs.

In addition, it provides information on the LED status indicators for the media servers, Avaya Ethernet switch(es), uninterruptible power supplies (UPSs), and different circuit packs. See LED indicators on page 71.

NOTE:

Circuit pack positions are usually given by cabinet, and slot. They may also be given by port. The term cabinet refers to five G650 Media Gateway TDM-cabled together in a rack, making up one port network. A port network is defined as a group of media gateways connected together with one TDM bus.

Perform these tasks to test the configuration:

CAUTION:

To prevent unnecessary trouble tickets, do not enable the alarms (Alarm Origination feature) until all installation and administration procedures are completed.

•Testing the TN2312BP IPSI circuit pack on page 69

•Testing the license file on page 70

NOTE:

Do these steps using a SAT session

NOTE:

For SAT commands you must be on the active media server.

Testing the TN2312BP IPSI circuit pack

1Type test ipserver-interfaceUUC and press Enter to test all clock and packet interface components within the IPSI circuit pack.

2Verify the screen displays Test Results screen similar to Figure 4, Sample IPSI 01A test results screen—page 1, on page 70.

Installing and Configuring the Avaya S8700 or S8710 Media Server	69
June 2004