Schneider Electric 312 manual Documentation structure

Page 6

Documentation structure

The following Altivar 312 technical documents are available on the Schneider Electric website (www.schneider-electric.com) as well as on DVD-ROM (reference VW3A8200).

Installation manual

This manual describes how to install and wire the drive.

Programming manual

This manual describes the functions, parameters and use of the drive terminal (integrated display terminal, optional graphic display terminal and optional remote terminal).

The communication functions are not described in this manual, but in the manual for the bus or network used.

Simplified manual

This manual is an extract from programming and installation manual. This manual is delivered with the drive.

Quick Start sheet

The Quick Start describes how to wire and configure the drive to start motor quickly and simply for simple applications. This document is delivered with the drive.

Communication manuals: CANopen, DeviceNet, Modbus and PROFIBUS DP

These manuals describe the assembly, connection to the bus or network, signaling, diagnostics, and configuration of the communication- specific parameters.

They also describe the protocol communication services.

Communication variables guide

This manual defines the drive control processes and the drive variables which can be accessed by the communication buses.

6	S1A10386 10/2009

Image 6

Contents Altivar Page Contents Important Information Please NoteBefore you begin Hazard of Electric SHOCK, EXPLOSION, or ARC FlashDocumentation structure Drive terminal displays IntroductionPresentation FormatsHardware setup Installing the card in the driveReceipt Hardware setup Characteristics and functions of the terminals Terminal Function Electrical characteristicsTherefore the direction of operation Number Terminal Electrical characteristics Connection to the Modbus base portConnection to the Profibus DP network Connection accessories Example of connectionWiring diagram for ATV 312 equipped with VW3 A312 Wire sizesRecommendations Configuration Address Switches 5-4-3-2-1Coding the drive address Drive default values At first power on with a Profibus DP option cardPower on after removing the Profibus DP option card Control of an ATV 312 from a Profibus DP option card Control of the drive when LAC = L1 or L2Control of the drive when LAC = L3 Parameter Value CommentControl via Profibus DP in native profile CiA402 DX Green LED Status DiagnosticsDiagnostic LEDs ST Red LED StatusCommunication fault management Code Name Probable cause RemedyProfibus DP mapping Profibus DP protocolOutput PZDs Input PZDsPKW request PKW aperiodic service Output PKWsInput PKWs Examples of PKW aperiodic exchanges PL7 output word Altivar Configuration of the communicationProject configuration PL7 input word AltivarConfiguration with SyCON additional Software Configuration of the slavePLC IO image / Altivar 312 DP slave mapping Save the projetPZD area PKW area Altivar TSX P57 354M TSX P57 354 M IO memoryReady for switch on Example of Control of the DriveAnimated operator screen example GSD installation Configuration of the deviceS1A10386 10/2009 PKW area PLC IO image / Altivar 312 DP slave mappingPZD area Altivar S7-315 PEW S7 315 PAW Parameter IO memorySupervision and control in Line mode IEC 61800-7 status chartReady to switch on and Switched on Drive initialized Not ready to switch on InitializationSwitch on disabled Configuration Operation enabled OperationalCMD control word W8501 ETA status word W3201 MSK = ETAATV312PROFIBUSDPS1A1038601 S1A10386 10/2009