Hardware setup
Install the card in ATV312 as follows:
1.Open the ATV312 front cover.
2 & 3. Remove the terminal board fixing screw and take off the ATV312 standard terminal board. (Be careful not to lose the terminal board fixing screw when removed since it may be used again.) This step does not apply if you are using an ATV312.... B (product without standard IO terminal).
4.Install the PROFIBUS DP card and secure it with the board fixing screw (M3 tapping screw tightening torque: 0.7 to 0.8Nm).
5.Stick the new cabling label above the PROFIBUS DP option card.
Stick the PROFIBUS DP card nameplate near the ATV312 nameplate. (Be careful not to cover slits on the ATV312 enclosure)
6.Perform wiring on the PROFIBUS DP card (see page 11).
7.Wire and screw the EMC clamps for the PROFIBUS DP cables (and control wires if required).
Note: To install or remove the terminal board, make it slide in or out in parallel with board.
S1A10386 10/2009 | 9 |