Chariot Carriers Chariot Baby Seat Please note Make sure you check all belt buckles are tight

Page 45

Insert the shoulder harness that is on the appropriate side of the baby seat through the lower or upper slot of the baby seat, depending on the size of the child.

Working towards the rear, insert the shoulder harness through the ring of the lap belt and the corresponding slot on the other side of the baby seat.

Connect the insert of the fastex buckle with its unit on the backrest of the trailer seat. (The fastex buckle should be in its lowest position.)

For centre-fitting, the right hand shoulder harness in the direction of travel is threaded through the baby seat as described above, and the insert of the fastener is connected with the unit of the left hand shoulder harness looking in direction of travel.

Illustration A

Now lay both the straps that are at the top end of the baby seat around the top crossbar inside the trailer.

Thread the strap through as illustrated…

…and pull the strap tight.

Finally pull all fastening straps tight. (If necessary the trailer body will need to be opened out again beforehand.)

If you want to adjust the seat to a flatter position, loosen both of the top fastening straps and pull the other four straps tight. If you want an adjustment of greater incline, the procedure is the same but reversed.

Please note: Make sure you check all belt buckles are tight.

Fitted baby seat ready to use in the centre and side position:

Please note:

Never transport your children without the safety belts being properly and fully adjusted, otherwise your child could be seriously or even fatally injured in the event of an accident!

45

Image 45

Contents Ab Modelljahr Benutzerhandbuch Gebruikershandleiding Owner‘s manualVanaf bouwjaar Models from 2006 onwardsInhaltsverzeichnis / Inhoud / Table of contents Achtung Produktionsbedingte Änderungen vorbehalten Montageanleitung Chariot BabysitzSicherheitshinweis Lieferzustand HinweisEinbau in die zweisitzigen Chariot-Fahrzeuge Lösen der Befestigungsgurte am BabysitzVorbereitende Schritte Montage der TeleskopstangeAnsicht von vorn AchtungBefestigung in den Modellen Comfort und Cheetah2 Befestigung des BabysitzesUnd ziehen Sie das Gurtband Befestigung in den Modellen Cabriolet, CX2 und Cougar2 Page Seitliche Positionierung Ziehen Sie abschließend alle Befestigungsgurte stramm an Ansicht von innen, Sitz zur Demonstration hochge- klapptMittige Positionierung Befestigung der Sicherheitsgurte Einbau in die einsitzigen Chariot-Fahrzeuge Montage der D-RingeBefestigung im Modell Cheetah1 Page Fertig montierter Babysitz Verletzungen erleiden Befestigung in den Modellen CX1 und Cougar1Page Fertig montierter Babysitz Verletzungen erleiden Bei den Modellen Cheetah1, Cheetah2 und Comfort Anschnallen des Babys und Einstellen der SicherheitsgurteSicherheitshinweise PflegehinweiseFalten der Chariot-Fahrzeuge De baby vastmaken en de veiligheidsgordels afstellen InhoudVeiligheidsaanwijzing Inbouwinstructies Chariot BabyzittingWordt als volgt geleverd OpmerkingMontage in de tweezits Chariot voertuigen De bevestigingsriemen losmakenVoorbereidende stappen Inbouw van de telescoopstangVooraanzicht Montage in de Comfort en Cheetah2 Bevestiging van de babyzittingAfbeelding staat aangegeven… Montage in de Cabriolet, CX2 en Cougar2 …en trek de riem iets aan Montage aan de zijkant Trek daarna alle bevestigingsriemen strak aan Montage in het midden De veiligheidsgordels bevestigen Installatie van de D-ringen Montage in de éénzits Chariot voertuigenMontage in de Cheetah1 Page Bevestiging in de CX1 en Cougar1 Page Volledig ingebouwde babyzitting verwondingen oplopen Voor de Cheetah1, Cheetah2 en Comfort De baby vastmaken en de veiligheidsgordels afstellenVeiligheidsaanwijzingen VerzorgingDe Chariot aanhangers opvouwen Table of contents Fitting Instructions Chariot Baby Seat Safety noteParts supplied Baby seat is not designed to be fitted to older modelsFitting to Two Seater Chariot Trailers Undoing the Baby Seat Securing StrapsPreliminary steps Fitting the Telescopic TubeFront view Please noteSecuring on the Comfort and Cheetah2 models Securing the Baby SeatPlease note Make sure you check all belt buckles are tight Securing on the Cabriolet, CX2 and Cougar2 models Page Lateral positioning Finally pull all fastening straps tight View from inside with seat lifted for clarityCentre-positioning Securing the safety belts Fitting to Single Seater Chariot Trailers Fitting the D-ringsSecuring on the Cheetah1 model Page Fully fitted baby seat Event of an accident Securing on the CX1 and Cougar1 modelsPage Fully fitted baby seat Event of an accident On the Cheetah1, Cheetah2 and Comfort models Fastening the Baby and Adjusting the Safety BeltsSafety Instructions Care of the Baby SeatFolding the Chariot Carriers