• Timer ( ) : selects the
• Repeat Shot ( 
) : Takes rapid series of 3 consecutive photos, approx. 1 second apart, when you press and hold the SHUTTER button. As with the timer, the camera will remain in this mode until you change it, or until the camera’s memory is full. This is indicated by the display showing “FUL” and a beep alarm.
• High/Low Quality (LQ) : When “LQ” is displayed, pressing “OK” will set the camera to low resolution mode (320x240
• AVI Mode: (
) : This mode sets the camera to take short movie clips (.avi files) rather than still photos. After this mode has been activated (press SHUTTER when the movie icon blinks), holding down the SHUTTER button will film an avi movie until you release it (or the memory is full). When the SHUTTER button is released, the camera reverts back to normal still photo operation (assuming unused memory remains). Repeat the steps to set AVI mode again if you wish to shoot
•Power Frequency Setting: (60/50 Hz) : This sets the correct electrical frequency to avoid any “flickering” in photos taken under fluorescent lighting. The normal default is “60” Hz (cycle), as used in the United States. If you are using the camera in a country with 50 Hz power frequency, press SHUTTER when the “50” icon blinks to select it.
• Delete Last ( 
): Pressing SHUTTER when the “Delete Last” icon is blinking will delete (erase) the last photo you took from the camera’s memory.
•Delete All ( 
) : When this mode is selected, the word “ALL” appears next to the trash can icon, and the number of total photos in memory will blink in the display. Press and hold the SHUTTER button to erase the entire memory contents. You will hear a tone that becomes higher as the photos are deleted. When the process is complete, the photo number display will reset to zero. If no button is pressed for 5 seconds, the camera returns to
6
more movie clips.
7
1/26/05 1:23:19 PM