Oregon Scientific DS6639 user manual Selecting a Flash Mode, Zooming, Using the Self-Timer

ENGLISH	Toggling Between On-Screen Display Settings
					Legend:
		Press		Press
						A	OSD with All Shooting
							Information Displayed
						B	OSD with Only Key
			Press				Information Displayed
						C	OSD is turned off

Selecting a Flash Mode

To toggle between Flash Modes, press the button on the camera and observe the Flash Icon on the On-Screen Display. When a picture with flash has been taken, the Status Lamp will blink while the flash is recharging. Once it stops blinking, you can resume taking pictures again. By default, the camera flash is set to auto. If you change this setting, the camera will memorize your setting when you turn the power off.

Inital Flash Settings

When you turn on your camera, the inital flash setting will vary depending on the level of your battery.

Battery Status	Inital Flash Setting
or	The flash setting is saved after your camera is switched off
	or the mode switch changes to another mode.
or	The inital flash setting is	. However, you can manually
	set the flash to other settings.

Toggling Between Flash Modes

Press Press

Press

8

Flash Mode Options Table										ENGLISH
Icon		Function		Description
		Auto		The flash may discharge automatically, depending on
				the light conditions.
		Flash On		The flash discharges regardless of lighting condition.
										FRANÇAIS
		Flash Off			Zooming
				The flash will not discharge.
Your digital camera comes with a x2 zooming function. By default, the zooming is
not enabled. In Camera, or Movie mode, increase zooming by pressing								(	p.4).
The Digital Zoom Icon on the OSD,						, indicates the current zoom level. To				ESPAÑOL
decrease the zooming, press					(	p.4).
Camera Mode Zooming Options
	Default						Zoom Larger
	x1.0 / x1.1 / x1.2 / x1.3 / x1.4 / x1.5 / x1.6 / x1.7 / x1.8 / x1.9 / x2.0
Movie Mode Zooming Options
			Default			Zoom Larger

x1.0 / x1.2 / x1.4 / x1.6 / x1.8 / x2.0

In movie mode, once the shutter button is pressed and recording starts, zooming cannot be further adjusted for the duration of the recording.

Using the Self-Timer

The Self-Timer function counts down before the camera automatically takes a picture by itself. This is useful when you want to be in the picture, and there is no one else to press the Shutter Release Button.

1.Slide the Mode Switch to Camera Mode.

2.Press ( p.4). The Self-Timer will engage. The front Self-Timer Lamp lights up.

3.Press the Shutter Release Button. Audible beeps can be heard, and the front Self-Timer Lamp will start blinking. The number displayed next to the OSD’s Self-Timer icon will appear and start counting down.

To hasten the countdown to 3 seconds, press the Shutter Release Button once again. 9

DS6639 Manual-Eng/Fre/Span (086-003300-060)