Operation
Symptom | Cause and/or corrective actions |
{ and 6 indicators flash and no function | • Moisture condensation has occurred. |
except for cassette ejection works. | m Remove the cassette and leave the camcorder for at |
| least 1 hour. (p. 91) |
The date or time indicator displays bars | • Reset the date and time. (p. 84) |
| |
|
|
The End Search function does not | • The cassette was ejected after you recorded on it. |
activate. | m The End Search function will not activate until you |
| make a new recording after reinserting the cassette. |
The tape does not move when a tape | • The POWER switch is set to CAMERA or OFF. |
transport button is pressed. | m Set it to VTR. (p. 23) |
| • The tape has run out. |
| m Rewind the tape or use a new one. (p. 23) |
The SteadyShot function does not activate. | • STEADYSHOT is set to OFF in the menu system. |
| m Set it to ON. (p. 52) |
| • The SteadyShot function does not work when the wide |
| mode is set to 16:9FULL. |
No sound or only a low sound is heard | • The stereo tape is played back with HiFi SOUND set to 1 |
when playing back a tape. | or 2 in the menu system. |
| m Set it to STEREO. (p. 32) |
Excessive | • The picture has been recorded with WIND set to ON in |
| the menu system. |
| m When there is no wind, set it to OFF. (p. 32) |
Recording stops in a few seconds. | • The START/STOP MODE switch is set to 5SEC or . |
mSet it to . (p. 15)
The autofocus function does not activate. | • Focus is set to the manual mode. | |
|
| m Set it to autofocus. (p. 57) |
| • | Shooting conditions are not suitable for autofocus. |
|
| m Set focus to manual mode to focus manually. (p. 57) |
The title display position shifts. | • | There are unwanted blanks before or after the title. |
|
| m Delete them, then select ↵. (p. 50) |
The fader function does not work. | • The START/STOP MODE switch is set to 5SEC or . |
mSet it to . (p. 15)
•A title is displayed.
mTurn off the title. (p. 48)
Continued to the next page
Additional information / Información adicional
97