Key Key designation Description | Panasonic HD3700H guide

Key	Key designation		Description
F1	OUTPUT	The mode opposite to the current one is established only while
	For selecting the	this key is held down. (When the key is pressed during TAPE
	audio/video output signals.	setting, the EE mode is established.)
		(If this key is pressed together with the F key, the display
		switches.)
		TAPE: Outputs playback signal.
		EE:	Outputs the EE system signals.
		≥Valid only in STOP, REC or EJECT mode. Invalid during
		playback.
		≥This key does not operate during CUE signal output.

F2	FREEZE	Outputs field memory 1 screen continuously.
	For outputtting the flash	Flash freeze frame is assumed only while this key is pressed.
	freeze frame.	If this key is pressed together with the F key, the setting can be
		fixed.
		ON: Output field memory screens.
		OFF: No freeze-framing.
F3	EJT CTL	RESET: Resets CTL1 when cassette is ejected. Resets CTL2
	For CTL operation in		when cassette is loaded.
	EJECT mode.	HOLD: Holds CTL values for both CTL1 and CTL2 when
			cassette is ejected.

F4	TC/CTL	TC:	Displays the time code.
	For timer mode switching.	CTL1: Displays the control signal value. (This can be reset to
			zero.)
		CTL2: Automatically resets the control signal value to zero
			when the cassette tape is loaded. The control signal
			value cannot be reset after this.

TC: Displays the TC value.

UB: Displays the UB value.

≥Valid only when [TC] is selected with F4 key.

≥Displays the time code readout value during playback. ≥Displays the time code value recorded on tape during

recording.

≥To display values generated at times other than recording, press the INPUT CHECK key.

F6	TC CLR	Valid only when the TC/CTL key is set to CTL1.
	For clearing the TC value.	RESET: CTL1 time data is reset to zero.
		Valid only when the TC/CTL key and the TC/UB key are set to TC.
	(TCG CLR)	RESET: TCG value is reset to zero when F key is
	For clearing the UBG	simultaneously pressed.
	value.	Valid only when the TC/CTL key is set to TC and the TC/UB key
		is set to UB.
	(UB CLR)	RESET: UBG value is reset to zero when F key is
	For clearing the UB value.	simultaneously pressed.
		However, since there are two UBG values, VITC UBG and LTC
		UBG, they are supported as follows by the TCR settings on the

TC/CHR menu.

TCR: AUTO Both VITC UBG and LTC UBG are reset to zero.

TCR: LTC LTC UBG is reset to zero.

TCR: VITC VITC UBG is reset to zero.

Continues to display the time code data which was displayed when the key was pressed.

≥Press again to release the hold value.

– 14 –

Key