Panasonic WV-CL934, WV-CL930 Setting of external synchronization switch, External terminal

Setting of external synchronization switch

When an external synchronizing signal input is provided to the external synchronization input connector on the rear side of the camera for loop through, select "Hi-Z". To terminate the con- nector, select "G/L 75 Ω". Select "G/L 75 Ω" for the normal situation, too.

External synchronization switch

Hi-Z G /L75	(UP)
NEAR	ABF/MENU FAR

(LEFT) (SET) (RIGHT) (DOWN)

External terminal

Important:

• Be sure to turn off the power of each device before connection.

Alarm output

Output specification: Open collector output (max. voltage: 16 V DC)

Off: 2 to 4 V DC, internally pulled up

On: Output voltage 1 V DC or less (max. drive current: 100 mA)

WV-CL930

120V ~ 60Hz

GEN-LOCK VIDEO OUT

POWER

ALARM	GND
	OUT
DAY/	GND
NIGHT	IN

Color/black-and-white input

Input specification: No-voltage make contact input (3 to 5 V DC, internally pulled up)

Color: Open or 3 to 5 V DC

Black and white: Make contact with GND (required drive current: 0.2 mA or more)

		GND
ALARM	GND	ALARM (alarm output)
DAY/	OUT	GND
	GND	DAY/NIGHT
NIGHT	IN
		(color input/BW input)

*The external terminal is the same between WV-CL930 and WV-CL934.

*When color input or black-and-white input is

enabled, set the black-and-white switching, "BW MODE" to "EXT". (☞ page 40)

*When an external device is connected, exercise care to avoid exceeding the rating.

*Applicable wire: AWG22-AWG28, solid wire/stranded wire Strip the end 9 to 10 mm {30" to 33"} of the wire and insert it.

9 to 10 mm {30" to 33"}

18