Panasonic WV-CL930, WV-CL934 operating instructions Step

ON: Displays black-and-white images.

OFF (default): Displays color images.

Note:

If a subject is always moving or the screen is occupied with a uniform color, brightness determination may be not per- formed successfully because the bright- ness is merely determined by information from the CCD image sensor. When "AUTO2" is selected, the wave length of the light source shall be 800 nm or longer.

Step 3

Move the cursor to "LEVEL" and select a brightness level at which switching between color and black-and-white images is per- formed from the following:

LOW: Switches from color to black-and-white images when the ambient brightness (illuminance) of the camera is approx.

0.1lx or less. (when the AGC MAX level is set to the top end.)

HIGH (default): Switches from color to black- and-white images when the ambient brightness (illuminance) of the camera is approx. 0.2 lx or less. (when the AGC MAX level is set to the top end.)

Step 4

Move the cursor to "DURATION TIME" and select a time for switching between color and black-and-white images from the following: (Default: 30 seconds)

10 sec.- 30 sec.- 60 sec.- 300 sec.

(S) (L)

Step 5

Move the cursor to "BURST (BW)", and decide whether or not to provide a burst sig- nal output in the black-and-white mode with use of "ON" or "OFF".

ON (default): Provides a burst signal output.

OFF: Does not provide any burst signal out- put.

Notes:

•The auto back focus function also allows users to correct out of focus when changing between color and black-and- white images. (☞ page 45)

•Images may not be displayed appropri- ately without burst signals when camera images are displayed in the black-and- white mode depending on a monitor or VCR model to be used. In such a case, set the burst signal output to "ON".

41