Advanced settings about motion detector function (MODE1)
The description below specifies the sensitivity level and detection area of the motion detector (MODE1).
To perform mask setting, set the image stabilizer, i.e. "STABILIZER" to "OFF". (☞ page 44)
"CAMERA SETUP" screen
**CAMERA | SETUP** 1/2 | |||||||||||
CAMERA ID | OFF |
|
|
|
| |||||||
|
| |||||||||||
|
| |||||||||||
ALC/ELC | ALC |
|
| |||||||||
| ||||||||||||
| ||||||||||||
SHUTTER | OFF | |||||||||||
AGC | ON |
|
| |||||||||
| ||||||||||||
| ||||||||||||
SENS UP | OFF | |||||||||||
SYNC | INT | |||||||||||
WHITE BAL | ATW1 |
|
| |||||||||
| ||||||||||||
| ||||||||||||
MOTION DET | OFF |
|
|
|
|
|
|
| ||||
DNR | HIGH |
|
|
|
|
|
|
| ||||
RESOLUTION | HIGH | |||||||||||
BW MODE |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| ||
Step 1
Set "MOTION DET" to "MODE1" and press the setting button.
→The "MODE1" screen appears.
Step 2
"MODE 1" screen
**MODE1**
LEVEL |
| ... | ...128 |
|
| - | + |
DWELL | TIME | 2S |
|
DISPLAY MODE
ALARM OFF
MASK SET
Move the cursor to "MASK SET" and press the setting button.
→The mask setting screen appears.
Step 3
Perform mask setting. The operation proce- dure is the same as the masking operation in the process of Sensing area setting for back- light compensation. (☞ page 27)
RET TOP END
Mask setting screen
Step 4
Hold down the setting button for approx. more than 2 seconds after completion of masking.
→The "MODE1" screen appears again.
Step 5
Move the cursor to "ALARM", and decide whether or not to provide an alarm signal in the demonstration mode with use of "ON" or "OFF".
ON: Provides an alarm signal output in the demonstration mode, and allows users to check the operation on the monitor when a motion is detection.
OFF (default): Provides no alarm signal out- put in the demonstration mode.
38