Rockford Fosgate RFX9220M manual Installation Wiring the System

Page 7

INSTALLATION

WIRING THE SYSTEM

NOTE: See diagram on following page to help you connect your system.

CAUTION: If you do not feel comfortable with wiring your new source unit, please see

your local Authorized Rockford Fosgate Dealer for installation.

CAUTION: Before installation, disconnect the battery negative (-) terminal to prevent damage to the unit, fire and/or possible injury.

1.Install the 16-Pin Power Harness by connecting the corresponding wires to the electrical and audio system. Solder and heat shrink all connections for a reliable installation. For each connection, cut a 1" piece of heat shrink tubing and slide over one of the wires. Strip each wire 3/8" then twist together and solder. Slide the tubing over the connection and shrink the tubing with a hot air gun until no bare wire is exposed.

2.Connect the BLACK (Ground) wire to chassis ground. Prepare the chassis ground by scraping any paint from the metal surface and thoroughly clean the area of all dirt and grease. Strip the end of the wire and attach a ring connector. Fasten the wire to the chassis using a non-anodized screw and star washer.

3.Connect the YELLOW (Backup) wire to a source of constant +12V (for retaining memory on user- programmed functions).The source should always have +12V, even when the ignition is off and the car is not running.

4.Connect the RED (ACC +B) wire (Ignition) to a source of switched +12V (is on only when ignition key is in “accessory” or “run” position). Connect the RED wire to a switched +12 volt positive source.The switched signal is usually taken from the ACC (accessory) position of the ignition. If the vehicle does not have an ACC position, connect the wire to the switched ON position of the ignition.

5.Connect the ORANGE (Dimmer) wire to the lighting switch terminal.This will dim the main display by 30% when the headlights are turned on.

6.Connect the LT. BLUE (Remote B+) wire to the “Remote Turn-On” leads of the amplifier(s).This will turn-on the external amplifiers when the source unit is powered on.

7.Connect the BLUE/RED (Auto Ant.) wire to the “Power Antenna” lead.This will raise a fully automatic antenna when the source unit is powered on, but only in Tuner Mode.

8.Connect the PINK (Telephone Mute) wire for cell phone mute to the wire on the cell phone harness that provides ground when the phone rings.

9a. Connecting Speakers (Not using external amplifier)

Connect the Speaker Wires to the corresponding speaker leads by soldering and heat shrinking all connections for a reliable installation. If only one pair of speakers is utilized in the system, use only the FRONT speaker leads and heat shrink the unused REAR leads to prevent from shorting out. Be sure to maintain speaker polarity. DO NOT chassis ground any speaker leads as unstable operation may result.

9b. Connecting Speakers (Using external amplifier)

Install the Preamp Output Harness by plugging the RCA cables into the corresponding extension RCAs that feed the input of the amplifiers. Be sure to route the signal cables away from any high current wires to prevent coupling noise from radiated electrical fields into the audio signal.The FRONT OUTPUT connects to the Front speaker's amplifier.The REAR OUTPUT connects to the Rear speaker's amplifier.The SUM OUTPUT connects to the Subwoofer amplifier.

10.Connect the AUX INPUT to the external audio source (this inserts the audio before the volume control on the source unit).The input voltage this circuit can accept is 1–3V RMS.

11.Connect the CD Changer (optional) by plugging the 8-pin DIN cable into the connector located at the rear of the source unit. DO NOT connect the optional Wired Remote into this connector.

12.Connect the Wired Remote (optional) by plugging the 8-pin DIN controller cable into the pigtail connector hanging from the rear of the source unit. DO NOT connect the optional CD Changer into this connector.

13.Connect the Antenna by plugging the antenna cable into the connector located at the rear of the source unit. Be sure the antenna is securely grounded to the vehicle for proper radio reception.

7

Image 7
Contents Installation Introduction Table of ContentsPrecautions Source Unit and Optional CD Changer Safety InstructionsInstallation PrecautionsIR Remote Controller Contents of CartonInstrument Panel Engine CompartmentISO-DIN Mount 9a. Connecting Speakers Not using external amplifier Installation Wiring the SystemSource Unit Features OFF Turns the source unit on and off Reset Button Operation Basic Initial Setup Detachable FaceplatePower ON/OFF Setup Options Operation Basic Volume KNOB/TONE ControlsOperation Basic Setting the Clock HoursSetting the Clock Minutes Tuner ModeTuner Options Panel Display DefaultPreset Buttons Operation Tuner Selecting a BandProgramming Station Titles AF/TP ModePTY Mode Operation Tuner Auto StoreAdvanced Operation Basic OperationOperation CD Player Fast Forward/Reverse Direct Track AccessTo Repeat a Track Forward/ReverseRFX 8620M CD Changer Operation Optional Accessory Remote Features RFX MR1 Wired Remote Control Optional AccessoryOperation Wired Remote Optional Title Erasing Programmable Disc Title MemoryOperation Title Programming Title MemoryNegotiating the MP3 Directory MP3 Player Operation Basic PlayingOperation MP3 Programmable Titling DN Down ButtonFast Forward/Fast Reverse Maximum Writing Speed and Bit DepthGeneral TroubleshootingError Initialize ErrorLoading Error Eject ErrorEngine Noise IR RemoteTroubleshooting Optional CD Changer General Model SpecificationsLimited Warranty Information Length of WarrantyNuméro de série Numéro de modèle Table DES MatièresCaractéristiques de lappareil -9 Fonctionnement de base Consignes DE Sécurité Avant DE CommencerDisques Compacts Télécommande InfrarougeInstallation des piles Mesures DE PrécautionCompartiment du moteur Installation Considérations Concernant LinstallationEmplacements DE Montage Voici la liste doutils requis pour linstallationBoîte à gant Installation StandardInstallation ISO-DIN Console centrale9a. Connexion des haut-parleurs sans utiliser dampli externe Installation Câblage DU SystèmeCaractéristiques DE Lappareil Tuner et la piste précédente en mode CDP/CDX Suivante en mode CDP/CDXDN Down Interrupteur DE Mise SOUS/HORS Tension Fonctionnement DE Base Réglage InitialFaçade Démontable Bouton DE RéinitialisationOptions DE Réglage App. & enfoncez Bout. centr TélécommandeApp. bouton centr Punch Sélection DE ModeFonctionnement DE Base Utilisation DE LhorlogeSélection Dune Station Panneau Daffichage PAR DéfautFonctionnement DU Tuner Sélection Dune Bande Options DU TunerProgrammation DES Titres DE Station Mode AF/TPMode PTY Fonctionnement DE Base Auto StoreÉjection dun disque Fonctionnement de baseFonctionnement avancé Fonctionnement DU Lecteur CDAvance/Retour Direct Track Access Accès direct aux pistesFonctionnement DU Tuner Répétition dune pisteChargement du magazine dans le changeur de Mode de changeur de CDRéinitialisation du changeur de CD Chargement dun disque dans le magazineFonctions de la télécommande Fonctionnement Télécommande À FIL EN OptionTélécommande à fil RFX M1 accessoire en option Branchement de la télécommandeTournez bouton ext Mémoire de titre de disque programmableFonctionnement DE LA Programmation DES Titres Effacer un titreUtilisation du répertoire MP3 Fonctionnement du lecteur MP3 Lecture de baseFonctionnement DE MP3 Titrage programmable Bouton DownAvance/Retour rapide Vitesse décriture et bits de profondeur maximumDépannage GénéralitésErreur Erreur deChargement Erreur déjectionBruit de moteur Télécommande infrarougeDépannage Dépannage DU Changeur DE CD ServiceGénéralités 9220 CaractéristiquesInformations SUR LA Garantie Limitée Durée de la garantieÍndice DE Materias IntroducciónNúmero de la serie Número del modelo Precaución Unidad Fuente Y Cambiador DE DC Opcional Instrucciones DE SeguridadContenido DE LA Caja PrecaucionesControl Remoto Infrarrojo Discos CompactosPanel de instrumentos Instalación Consideraciones Para LA InstalaciónLugares DE Montaje Compartimiento del motorSoporte Estándar Panel centralGuantera Debajo del tablero de instrumentos9b. Conexión de altavoces Usando un amplificador externo 9a. Conexión de altavoces sin usar un amplificador externoCaracterísticas DE LA Unidad Fuente No conecte el cambiador opcional de CD en este puertoCaracterísticas DE LA Unidad Fuente Alimentación DE Corriente APAGAR/PRENDER Funcionamiento Básico Preparación InicialCara Frontal Desprendible Botón DE ReinicioPresione el centro Funcionamiento Básico Botón DE VOLUMEN/CONTROLES DE TonoOpciones DE Ajuste Gire haciaPresentación DE LA Pantalla Funcionamiento BásicoFuncionamiento DEL Reloj Selección DE ModosOpciones DEL Sintonizador Funcionamiento SintonizadorPresentación DEL Panel POR Omisión Funcionamiento Sintonizador Selección DE BandasModo PTY Funcionamiento Sintonizador Almacenamiento AutomáticoProgramación DE Títulos Para Radiodifusoras Modo AF/TPFuncionamiento avanzado Funcionamiento BásicoFuncionamiento Reproductor DE DC Exploración de pistas Para repetir una pistaAdelanto/Retroceso Adelanto/Retroceso rápidosPuesta del Cargador en el Cambiador de Expulsión del cargadorReinicio del Cambiador de DC Carga del disco en el CargadorCaracterísticas del control remoto Operación Control Remoto Opcional CON CableConexión de la luz Conexión del control remotoGire hacia afuera Funcionamiento Programación DE TítulosMemorización del Título Borrado de TítulosNavegación del directorio MP3 Funcionamiento del reproductor de MP3 Reproducción básicaFuncionamiento MP3 Estructura del Directorio Botón DownAdelanto Rápido/Reversa Rápida Titulación ProgramableContraluz Solución DE ProblemasNo hay Iluminación deEl disco está torcido, rajado o DiscoSeveramente dañado El Remoto Infrarrojo tiene poco alcance Remoto InfrarrojoFuente Ruido del motorSolución DE Problemas DEL Cambiador DE DC General 9220 EspecificacionesInformación Sobre LA Garantía Limitada Duración de la garantía

RFX9220M specifications

The Rockford Fosgate RFX9220M is a powerhouse marine-grade digital media receiver designed to elevate your audio experience while out on the water. Built for durability and performance, this receiver boasts a host of features that cater to both music enthusiasts and casual listeners alike.

One of the standout characteristics of the RFX9220M is its IPX6-rated water resistance. This means that it is specifically engineered to withstand water splashes and exposure to the elements, making it perfect for boating, jet skiing, or any marine activities. The rugged design ensures that your audio equipment remains safe while enhancing your outdoor adventures.

In terms of audio performance, the RFX9220M includes a high-efficiency built-in amplifier that delivers robust sound quality. With its peak power output, it can drive your connected speakers effectively, providing a rich sound experience. The receiver also features a variable bass boost, allowing users to customize their low-end response based on individual preferences.

The RFX9220M is equipped with Bluetooth connectivity, enabling hassle-free wireless streaming from smartphones and other compatible devices. The receiver supports hands-free calling and streaming, ensuring you can stay connected while focusing on the waves. Additionally, it is equipped with a USB port that allows for direct playback of music from flash drives, providing another option for enjoying your favorite tunes while on the water.

Users will appreciate the large, easy-to-read LCD display, which is designed for visibility whether you are in bright sunlight or under cloudy skies. The user interface is intuitive, allowing for easy navigation through various settings and playback options. The receiver also supports multiple audio formats, ensuring that your music collection, regardless of the source, can be played seamlessly.

Furthermore, the RFX9220M includes customizable equalizer settings that let you fine-tune the audio output according to your listening environment. With multiple preamp outputs, the receiver can effortlessly connect to additional amplifiers, enhancing the overall sound system for enthusiasts craving greater power and dynamism.

In summary, the Rockford Fosgate RFX9220M is an exceptional choice for anyone looking to upgrade their marine audio system. With its rugged construction, impressive sound quality, and user-friendly features, it perfectly combines functionality and style, making it a worthy investment for days spent on the water.