AMX manual Removing the MVP-WDS Faceplate, MVP Support Cradle

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box

Although there are wiring knockouts are on both sides of the conduit box, the knockouts on the right side will be used for the MVP-WDS (wall docking station) connectors, so always secure the conduit box to the stud using the Stud Mounting Holes on the left side of the box.

2.Using either nails or screws, fasten the conduit box to the stud through the five Stud Fastening Holes.

3.Remove the wiring knockouts from the right side of the conduit box to accommodate cabling to the MVP-WDS.

4.Thread the USB and Power cables through the knockouts on the right of the conduit box. It is recommended that you test these connections before fully installing the WDS.

5.Install the drywall/sheetrock before inserting the MVP-WDS into the conduit box.

Removing the MVP-WDS Faceplate

The faceplate must be removed from the main MVP-WDS unit before any installation procedures can be done. The unit is shipped without the Die Cut Foam covers (60-5965-47) installed over the two #6-32 Faceplate Security Screws. The foam covers are installed over the faceplate screws only after the installation is complete and the support cradle is retracted.

1.Place the MVP-WDS face up on a flat level surface.

2.Connect the mini-Phoenix connector from a compatible 12V power supply to the PWR connector on the side panel (see FIG. 4) to apply power.

Faceplate

Die Cut

Foam covers

MVP Support Cradle

MVP Alignment Guide Pin

MVP Interface Connector pins

Security Release pushbutton/LEDs

MVP Alignment Guide Pin

FIG. 4 MVP-WDS Docking Station components (front view)

Battery Compartment

Security Latch

Battery Compartment Latch

2-pin mini-Phoenix power connector

USB connectors (2)

3.Open the Battery Compartment and press the Cradle Activation pushbutton (recessed white button located near the pins in Battery Slot #2) to angle the Support Cradle forward (FIG. 5).

MVP-WDS Wall Docking Station for MVP Panels 5