AMX MVP-WDS manual Device and System values

Page 33

Upgrading the Docking Station Firmware

Selected Docking Station Firmware file

 

Description field for selected Kit file

 

Firmware download status

Device and System values

must match the System and Device values listed in the Project Navigator window

FIG. 3 Send to NetLinx Device dialog (showing docking station firmware update via USB)

Firmware upgrades can not be done directly to the docking station but must be routed through the MVP panel.

10.Click the Reboot Device checkbox. This causes the touch panel to reboot after the firmware update process is complete. The reboot of the panel can take up 30 seconds after the firmware process has finished.

11.Click Send to begin the transfer. The file transfer progress is indicated on the bottom-right of the dialog.

12.As the panel is rebooting, temporarily unplug the USB connector on the panel until the panel has completely restarted.

13.Once the first panel page has been displayed, reconnect the USB connector to the panel.

14.Right-click the associated System number and select Refresh System. This causes a refresh of all project systems, establishes a new connection to the Master, and populates the System list with devices on your particular system.

15.After the panel powers-up, press and hold the two lower buttons on both sides of the display for 3 seconds to continue with the setup process and proceed to the Setup page.

16.Press the Batteries button (located on the lower-left) to open the Batteries page and confirm the new firmware does not read 0.00.

If the Base Version field displays 0.00, this means there was an error in the firmware upload process. Re-install the base firmware and re-confirm that the new base version no longer reads 0.00.

MVP-WDS Wall Docking Station for MVP Panels

27

 

 

Page 32 Page 34
Image 33
Page 32 Page 34
Contents MVP-WDS AMX Limited Warranty and Disclaimer FCC Information Page Table of Contents Page Overview MVP-WDS Wall Docking Station & CB-MVPWDS Conduit BoxMVP-WDS Specifications SpecificationsLED Indicators MVP-WDS docking station connector locationsInstalling the CB-MVPWDS Conduit Box InstallationMVP Support Cradle Removing the MVP-WDS FaceplateSecurity Latch Faceplate Securing Latches Faceplate Connectors Installing the MVP-WDS in a CB-MVPWDS Conduit Box Installing the MVP-WDS Using Expansion Clips MVP-WDS Wall Mount cutout dimensions using expansion clips Replacement drywall clip sets cab be ordered from AMX Screws not included Connecting a Power Supply Powering the MVP-WDSReplacing the Faceplate on the MVP-WDS Connecting and Using USB Input Devices on the Stations Using the 3.5mm mini-Phoenix Connector for PowerSecuring an MVP Panel to an MVP-WDS Interface Connector Pins and FunctionsRemoving an MVP Panel from an MVP-WDS Unsecured MVP removal from an MVP-WDSSecured MVP removal from an MVP-WDS Installing and Charging Batteries in the Docking Stations Installing MVP-BP Batteries Into the MVP-WDSUndock-USER String Removing the original faceplate Installing the MVP-WDS-SK Silver Conversion KitSecurity Latch Faceplate securing latches Gap opening Removing the attached circuit boards a & B Installing the new conversion kit’s pivot unit componentsInstallation of silver cradle pivot and battery cover Installing the new silver faceplateMVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box Prepare the Docking Station for firmware transfer via USB Upgrading the Docking Station FirmwareDefault Modero panel value is Upgrade the Docking Station firmware via USBDevice and System values Upgrading the Docking Station Firmware Page It’s Your World Take Control
Top Page Image Contents