AMX Connecting a Power Supply, Replacing the Faceplate on the MVP-WDS, Powering the MVP-WDS

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box

Replacing the Faceplate on the MVP-WDS

1.Temporarily apply power to the MVP-WDS by connecting the terminal end of the power cable to the power supply.

2.Press the Cradle Activation Pushbutton (located inside the MVP-WDS battery compartment, next to the battery pins in Battery Slot #2 - see FIG. 5) to angle the Support Cradle forward.

3.Temporarily remove power from the MVP-WDS to maintain the support cradle at this angle and keep it from retracting back into the MVP-WDS.

4.Slide the Faceplate over the angled Support Cradle, toward the Security Release pushbutton’s circuit board on the MVP-WDS (FIG. 9).

5.Gently press the faceplate down and under the Security Latch until it rests against the Mounting Tabs of the MVP-WDS main unit.

Be sure to snap the Faceplate Connectors back into their respective Latches (located along the bottom rim of the faceplate - see FIG. 7 on page 7).

Verify that the Security Release Pushbutton is properly aligned over it’s LEDs and circuit board on the MVP-WDS main unit.

Verify that the two faceplate security screw holes on both the Faceplate and the main MVP-WDS unit are properly aligned.

6.Insert and secure the two #6-32 Faceplate Security Screws into the top rim of the Faceplate using a grounded Phillips-head screwdriver.

7.Apply power to the MVP-WDS by connecting the terminal end of the power cable to the power supply.

8.Press the Cradle Activation pushbutton to cause the MVP Support Cradle to angle backwards and lie flush against the main unit.

9.Remove the two adhesive plastic Die Cut Foam covers (60-5965-47) from the strip included within the Installation Kit bag.

10.Adhere these two plastic Die Cut Foam covers into the two notches where the Faceplate Security Screws are located.

Refer to the Securing an MVP Panel to an MVP-WDSsection on page 15 and Removing an MVP Panel from an MVP-WDSsection on page 16.

Connecting a Power Supply

The MVP-WDS Docking Station receives power from a 12-VDC compliant power supply using a 2-pin 3.5 mm mini-Phoenix connector.

Static electricity can damage electronic circuitry. Before touching the unit, discharge any accumulated static electricity from your body by touching a grounded metal object.

Powering the MVP-WDS

The MVP-WDS uses a 12-VDC compliant power supply (not included) to provide power to the MVP panel, while charging internal batteries. Once MVP batteries are fully charged, the MVP-WDS begins charging MVP-BP batteries inserted within its battery compartments.

1.Connect the terminal end of the power supply to the rear PWR connector on the WDS.

2.Provide power to the MVP-WDS by connecting the AC power cord to an external power source.

MVP-WDS Wall Docking Station for MVP Panels 13