AMX manual Installing the MVP-WDS in a CB-MVPWDS Conduit Box

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box

Installing the MVP-WDS in a CB-MVPWDS Conduit Box

The conduit box must be mounted prior to continuing this section. Refer to the Installing the CB-MVPWDS Conduit Box section on page 4 for detailed pre-wall installation instructions.

The faceplate must be removed prior to any surface installation (see the Removing the MVP- WDS Faceplate section on page 5).

Verify that the USB and power cables have been threaded through the knockouts on the right of the conduit box. Leave enough slack in the wiring to accommodate re-positioning of the panel.

1.Connect the 2-pin power connector and USB cables to the WDS. The WDS must be installed with these attached. The USB connectors can be from either a USB extension cable, or a wireless USB RF transmitter.

Verify that the terminal end of the power cable is not connected to a power source before plugging in the 2-pin power connector.

2.Insert the WDS into the conduit box, so that the Mounting Tabs on the WDS lie flush against the conduit box (FIG. 9).

#4-40 Mounting Screws (four - not included) secure the WDS to the Conduit Box.

#6-32 Faceplate

Security Screws (2)

Die Cut Foam covers (2)

Faceplate

CB-MVPWDS

Conduit Box

Mounting Tab

MVP-WDS (Main unit)

FIG. 9 MVP-WDS installation configuration within a CB-MVPWDS Conduit Box

3.Using a grounded Phillips-head screwdriver, insert and secure four #4-40 Mounting Screws (not included) into their corresponding holes located along the sides of the MVP-WDS until the WDS is securely fastened to the conduit box, and is flush against the wall.

4.Follow the steps outlined in the Replacing the Faceplate on the MVP-WDSsection on page 13 to re- install the faceplate.

8 MVP-WDS Wall Docking Station for MVP Panels