AMX MVP-WDS manual Screws not included

Page 18

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box

Verify that the terminal end of the power cable is not connected to a power source before plugging in the 2-pin power connector.

The USB connectors can be from either a USB extension cable, or a wireless USB RF transmitter.

Don’t disconnect the PWR and USB connectors from the MVP-WDS. The unit must be installed with these attached.

4.Test the Power and USB connections before fully installing the WDS. Refer to the LED Indicators table on page 3 for blink pattern information.

Applying power to the MVP-WDS causes the MVP Support Cradle to retract back into docking station.

5.Disconnect the terminal end of the power cable from the connected power supply.

6.Carefully insert the main unit into the cutout until the Mounting Tabs on the MVP-WDS lie flush against the wall (FIG. 13).

7.Insert and secure four #4-40 Mounting Screws (not included) into their corresponding holes located along the sides of the WDS (using a grounded Phillips-head screwdriver) until the WDS is secured and is flush against the wall.

8.Follow the steps outlined in the Replacing the Faceplate on the MVP-WDSsection on page 13 to angle the MVP Support Cradle forward and re-install the faceplate.

Flat surface (can include a wall, podium, or other level surface)

Install the four #4-40 mounting screws into the four holes

(screws not included)

Faceplate security screws (2)

Die Cut Foam covers (2)

A - Faceplate (bezel)

Attachment is done along the edges of the cutout

Mounting Tab

B- MVP-WDS (Main unit)

FIG. 13 MVP-WDS installation configuration for solid surfaces

12

MVP-WDS Wall Docking Station for MVP Panels

Page 17 Page 19
Image 18
Page 17 Page 19
Contents MVP-WDS AMX Limited Warranty and Disclaimer FCC Information Page Table of Contents Page MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box OverviewSpecifications MVP-WDS SpecificationsMVP-WDS docking station connector locations LED IndicatorsInstallation Installing the CB-MVPWDS Conduit BoxRemoving the MVP-WDS Faceplate MVP Support CradleSecurity Latch Faceplate Securing Latches Faceplate Connectors Installing the MVP-WDS in a CB-MVPWDS Conduit Box Installing the MVP-WDS Using Expansion Clips MVP-WDS Wall Mount cutout dimensions using expansion clips Replacement drywall clip sets cab be ordered from AMX Screws not included Connecting a Power Supply Powering the MVP-WDSReplacing the Faceplate on the MVP-WDS Using the 3.5mm mini-Phoenix Connector for Power Connecting and Using USB Input Devices on the StationsInterface Connector Pins and Functions Securing an MVP Panel to an MVP-WDSRemoving an MVP Panel from an MVP-WDS Unsecured MVP removal from an MVP-WDSSecured MVP removal from an MVP-WDS Installing and Charging Batteries in the Docking Stations Installing MVP-BP Batteries Into the MVP-WDSUndock-USER String Installing the MVP-WDS-SK Silver Conversion Kit Removing the original faceplateSecurity Latch Faceplate securing latches Gap opening Installing the new conversion kit’s pivot unit components Removing the attached circuit boards a & BInstalling the new silver faceplate Installation of silver cradle pivot and battery coverMVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box Upgrading the Docking Station Firmware Prepare the Docking Station for firmware transfer via USBUpgrade the Docking Station firmware via USB Default Modero panel value isDevice and System values Upgrading the Docking Station Firmware Page It’s Your World Take Control
Top Page Image Contents