Removing an MVP Panel from an MVP-WDS

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box

When the MVP is properly docked, the following message is displayed on the panel (FIG. 17).

On-screen Docking message

Docking Status button (illuminates to also give an indication that the panel is properly docked)

FIG. 17 System message - panel is properly docked

Proper docking and communication can be verified via the on-screen system message, or the illuminated Docking Status button on the Protect Setup page, or the right LED on the docking station.

If the MVP is docked properly and communicating, the right LED on the MVP-WDS will remain brightly illuminated.

Refer to the LED Pattern Indicators for the MVP-WDS table on page 3 for more information.

If the panel is not securely attached, the electromagnet on the TDS will not be activated, and the panel could fall forward and be damaged.

Removing an MVP Panel from an MVP-WDS

The MVP security feature enables a security code that is entered into an on-screen password keypad. This password is configured within the MVP panel’s Password Setup page.

Refer to the MVP-7500/8400 Operation/Reference Guide (available online at www.amx.com) for more information on setting up a User Access username and password.

Unsecured MVP removal from an MVP-WDS

1.Press and hold the security release pushbutton.

The MVP-WDS will release the security latch from the rear of the MVP and the MVP Support Cradle will angle forward to present the MVP for removal.

2.Lift the panel off the alignment guide pins and remove it from the support cradle.

3.Allow the MVP-WDS one second to retract the Support Cradle.

Secured MVP removal from an MVP-WDS

1.Press and hold the ecurity release pushbutton until the on-screen keypad appears on the MVP.

2.Enter the security release password.

3.Press Done when finished. Allow the MVP-WDS one second to process the release request and turn off the electromagnet.

4.Angle the MVP forward.

16	MVP-WDS Wall Docking Station for MVP Panels