AMX MVP-WDS manual FCC Information

Page 3

FCC Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received; including interference that may cause undesired operation.

Federal Communications Commission (FCC) Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

FCC RF Radiation Exposure Statement

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed an operated with a minimum distance of 20 centimeters between the radiator and your body.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents MVP-WDS AMX Limited Warranty and Disclaimer FCC Information Page Table of Contents Page Overview MVP-WDS Wall Docking Station & CB-MVPWDS Conduit BoxMVP-WDS Specifications SpecificationsLED Indicators MVP-WDS docking station connector locationsInstalling the CB-MVPWDS Conduit Box InstallationMVP Support Cradle Removing the MVP-WDS FaceplateSecurity Latch Faceplate Securing Latches Faceplate Connectors Installing the MVP-WDS in a CB-MVPWDS Conduit Box Installing the MVP-WDS Using Expansion Clips MVP-WDS Wall Mount cutout dimensions using expansion clips Replacement drywall clip sets cab be ordered from AMX Screws not included Connecting a Power Supply Powering the MVP-WDSReplacing the Faceplate on the MVP-WDS Connecting and Using USB Input Devices on the Stations Using the 3.5mm mini-Phoenix Connector for PowerSecuring an MVP Panel to an MVP-WDS Interface Connector Pins and FunctionsRemoving an MVP Panel from an MVP-WDS Unsecured MVP removal from an MVP-WDSSecured MVP removal from an MVP-WDS Installing and Charging Batteries in the Docking Stations Installing MVP-BP Batteries Into the MVP-WDSUndock-USER String Removing the original faceplate Installing the MVP-WDS-SK Silver Conversion KitSecurity Latch Faceplate securing latches Gap opening Removing the attached circuit boards a & B Installing the new conversion kit’s pivot unit componentsInstallation of silver cradle pivot and battery cover Installing the new silver faceplateMVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box Prepare the Docking Station for firmware transfer via USB Upgrading the Docking Station FirmwareDefault Modero panel value is Upgrade the Docking Station firmware via USBDevice and System values Upgrading the Docking Station Firmware Page It’s Your World Take Control
Top Page Image Contents