AMX MVP-WDS manual Upgrading the Docking Station Firmware

Page 31

Upgrading the Docking Station Firmware

Upgrading the Docking Station Firmware

The following accessory devices are firmware upgradeable:

MVP-TDS Table Top Docking Station (FG5965-10)

MVP-WDS Wall/Flush Mount Docking Station - Black (FG5965-11)

MVP-WDS Wall/Flush Mount Docking Station - Silver (FG5965-21)

This device is not given a unique device number which would ordinarily appear within the Online Tree tab of NetLinx Studio. It appears as a battery base below the target panel which it is a part of as seen below in FIG. 1.

Target Panel Device #

TDS/WDS

(station version)

NetLinx Studio Online Tree tab

Accessory’s corresponding firmware page

FIG. 1 Location of Firmware version information within NetLinx Studio

The only way to upgrade the firmware of these accessory items is to send the accessory’s firmware through a target panel. Its this panel’s device number which is entered within the Send to NetLinx Device transfer dialog in Studio.

Step 1: Prepare the Docking Station for firmware transfer via USB

Before beginning with this section:

Verify the MVP is securely attached to the docking station and communicating properly.

Verify that the panel is communicating from the mini-USB port to the Virtual NetLinx Master (VNM).

1.Configure the NetLinx Master for IP communication. Refer to the MVP-7500/8400 Operation/ Reference Guide (available online at www.amx.com) for information.

2.After the panel powers-up, press and hold the two lower buttons on both sides of the display for 3 seconds to continue with the setup process and proceed to the Setup page.

3.Press the Batteries button to open the Batteries page (FIG. 2).

MVP-WDS Wall Docking Station for MVP Panels

25

 

 

Page 30 Page 32
Image 31
Page 30 Page 32
Contents MVP-WDS AMX Limited Warranty and Disclaimer FCC Information Page Table of Contents Page Overview MVP-WDS Wall Docking Station & CB-MVPWDS Conduit BoxMVP-WDS Specifications SpecificationsLED Indicators MVP-WDS docking station connector locationsInstalling the CB-MVPWDS Conduit Box InstallationMVP Support Cradle Removing the MVP-WDS FaceplateSecurity Latch Faceplate Securing Latches Faceplate Connectors Installing the MVP-WDS in a CB-MVPWDS Conduit Box Installing the MVP-WDS Using Expansion Clips MVP-WDS Wall Mount cutout dimensions using expansion clips Replacement drywall clip sets cab be ordered from AMX Screws not included Powering the MVP-WDS Connecting a Power SupplyReplacing the Faceplate on the MVP-WDS Connecting and Using USB Input Devices on the Stations Using the 3.5mm mini-Phoenix Connector for PowerSecuring an MVP Panel to an MVP-WDS Interface Connector Pins and FunctionsUnsecured MVP removal from an MVP-WDS Removing an MVP Panel from an MVP-WDSSecured MVP removal from an MVP-WDS Installing MVP-BP Batteries Into the MVP-WDS Installing and Charging Batteries in the Docking StationsUndock-USER String Removing the original faceplate Installing the MVP-WDS-SK Silver Conversion KitSecurity Latch Faceplate securing latches Gap opening Removing the attached circuit boards a & B Installing the new conversion kit’s pivot unit componentsInstallation of silver cradle pivot and battery cover Installing the new silver faceplateMVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box Prepare the Docking Station for firmware transfer via USB Upgrading the Docking Station FirmwareDefault Modero panel value is Upgrade the Docking Station firmware via USBDevice and System values Upgrading the Docking Station Firmware Page It’s Your World Take Control
Top Page Image Contents