AMX MVP-WDS manual Security Latch

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box

Battery Compartment Cover

MVP Support

Cradle

Battery slot 1

Battery slot 2

Cradle Activation

pushbutton (located inside Battery Slot #2)

Power supply feed

Battery Compartment Latch

FIG. 5 Cradle activation pushbutton location and cradle angling

4.Close the battery cover and disconnect the power connector to remove power from the unit and maintain the support cradle in the forward position.

5.Remove the two #6-32 Faceplate Security Screws from the top rim of the faceplate, using a grounded Phillips-head screwdriver (FIG. 6).

Security Release pushbutton

Security Latch

Faceplate

FIG. 6 Faceplate screw removal

MVP Support Cradle

#6-32 Faceplate Security Screws

6.Angle the top rim of the faceplate upwards, and pull it up and over the Security Latch.

7.Grab the bottom rim of the faceplate and push it up (towards the support cradle), then pull it out, sliding the four faceplate connectors out of the latches along the bottom of the WDS (FIG. 7).

6 MVP-WDS Wall Docking Station for MVP Panels