AMX manual Installing the MVP-WDS Using Expansion Clips

Page 15

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box

Installing the MVP-WDS Using Expansion Clips

Expansion clips are mounted through the four oval holes located along the rim of the MVP-WDS. As the screw is tightened, the clip bends toward the insertion hole and into the wall. This bending creates a "grip" on the wall by either pressing onto the wall or by securing the drywall between the housing and the drywall clip.

The faceplate must be removed prior to any surface installation (see the Removing the MVP- WDS Faceplate section on page 5).

The outer frame Mounting Tabs must be flush against the mounting surface.

1.Cut out the surface for the WDS using the dimensions shown in installation diagram SP-5965-01(reproduced in FIG. 10 on page 10). It is recommended that you cutout the surface slightly smaller than what is outlined in the installation drawings so that you can make any necessary cutout adjustments.

Be sure to cut out the four notches along the sides to accommodate the four drywall expansion clips (included).

2.Thread the USB and Power cables through the surface opening, leaving enough slack in the wiring to accommodate re-positioning of the unit.

3.Connect the 2-pin power connector and USB cables to the WDS. The WDS must be installed with these attached. The USB connectors can be from either a USB extension cable, or a wireless USB RF transmitter.

Verify that the terminal end of the power cable is not connected to a power source before plugging in the 2-pin power connector.

4.Install the four sets of drywall screws and expansion clips into the four oval notch locations along both sides of the main unit (FIG. 11).

MVP-WDS Wall Docking Station for MVP Panels

9

 

 

Page 14 Page 16
Image 15
Page 14 Page 16
Contents MVP-WDS AMX Limited Warranty and Disclaimer FCC Information Page Table of Contents Page Overview MVP-WDS Wall Docking Station & CB-MVPWDS Conduit BoxMVP-WDS Specifications SpecificationsLED Indicators MVP-WDS docking station connector locationsInstalling the CB-MVPWDS Conduit Box InstallationMVP Support Cradle Removing the MVP-WDS FaceplateSecurity Latch Faceplate Securing Latches Faceplate Connectors Installing the MVP-WDS in a CB-MVPWDS Conduit Box Installing the MVP-WDS Using Expansion Clips MVP-WDS Wall Mount cutout dimensions using expansion clips Replacement drywall clip sets cab be ordered from AMX Screws not included Connecting a Power Supply Powering the MVP-WDSReplacing the Faceplate on the MVP-WDS Connecting and Using USB Input Devices on the Stations Using the 3.5mm mini-Phoenix Connector for PowerSecuring an MVP Panel to an MVP-WDS Interface Connector Pins and FunctionsRemoving an MVP Panel from an MVP-WDS Unsecured MVP removal from an MVP-WDSSecured MVP removal from an MVP-WDS Installing and Charging Batteries in the Docking Stations Installing MVP-BP Batteries Into the MVP-WDSUndock-USER String Removing the original faceplate Installing the MVP-WDS-SK Silver Conversion KitSecurity Latch Faceplate securing latches Gap opening Removing the attached circuit boards a & B Installing the new conversion kit’s pivot unit componentsInstallation of silver cradle pivot and battery cover Installing the new silver faceplateMVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box Prepare the Docking Station for firmware transfer via USB Upgrading the Docking Station FirmwareDefault Modero panel value is Upgrade the Docking Station firmware via USBDevice and System values Upgrading the Docking Station Firmware Page It’s Your World Take Control
Top Page Image Contents