AMX MVP-WDS manual Security Latch

Page 25

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box

Battery Compartment Cover

Die Cut Foam Cover location

MVP Support Cradle

Cradle Activation

pushbutton (located inside Battery Slot #2)

 

 

Power supply feed

 

 

Battery Compartment Latch

 

(2-pin 3.5 mm mini-Phoenix)

FIG. 18 Cradle activation pushbutton location and cradle angling

7.Disconnect the 2-pin mini-Phoenix connector from the side of the docking station to remove power from the unit and maintain the support cradle in this angled position.

8.Close the battery cover.

9.Remove the two #6-32 Faceplate Security Screws from the top rim of the faceplate (FIG. 19) and place these aside.

Security Release pushbutton

Security Latch

Faceplate

FIG. 19 Faceplate screw removal

MVP Support Cradle

#6-32 Faceplate Security Screws

10.Position the MVP-WDS unit so the Security Release pushbutton is positioned directly in front of you, then grasp the top rim of the faceplate and begin to angle it upwards. At this point, the faceplate is still connected to the Security Latch (located behind the securing magnet, as shown in FIG. 19).

11.Hold down the unit with both hands and (in one motion), pull the top rim of the faceplate directly towards you and then over the Security Latch to allow it to be removed from the main unit.

12.Grab the bottom rim of the faceplate and place your thumbs just below either side of the Security Release Pushbutton.

13.In one single motion, use your thumbs to push the bottom rim towards the cradle, and then pull it upwards to slide the four faceplate connectors up and away from their respective securing latches along the bottom of the MVP-WDS (FIG. 20).

MVP-WDS Wall Docking Station for MVP Panels

19

 

 

Image 25
Contents MVP-WDS AMX Limited Warranty and Disclaimer FCC Information Page Table of Contents Page Overview MVP-WDS Wall Docking Station & CB-MVPWDS Conduit BoxMVP-WDS Specifications SpecificationsLED Indicators MVP-WDS docking station connector locationsInstalling the CB-MVPWDS Conduit Box InstallationMVP Support Cradle Removing the MVP-WDS FaceplateSecurity Latch Faceplate Securing Latches Faceplate Connectors Installing the MVP-WDS in a CB-MVPWDS Conduit Box Installing the MVP-WDS Using Expansion Clips MVP-WDS Wall Mount cutout dimensions using expansion clips Replacement drywall clip sets cab be ordered from AMX Screws not included Powering the MVP-WDS Connecting a Power SupplyReplacing the Faceplate on the MVP-WDS Connecting and Using USB Input Devices on the Stations Using the 3.5mm mini-Phoenix Connector for PowerSecuring an MVP Panel to an MVP-WDS Interface Connector Pins and FunctionsUnsecured MVP removal from an MVP-WDS Removing an MVP Panel from an MVP-WDSSecured MVP removal from an MVP-WDS Installing MVP-BP Batteries Into the MVP-WDS Installing and Charging Batteries in the Docking StationsUndock-USER String Removing the original faceplate Installing the MVP-WDS-SK Silver Conversion KitSecurity Latch Faceplate securing latches Gap opening Removing the attached circuit boards a & B Installing the new conversion kit’s pivot unit componentsInstallation of silver cradle pivot and battery cover Installing the new silver faceplateMVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box Prepare the Docking Station for firmware transfer via USB Upgrading the Docking Station FirmwareDefault Modero panel value is Upgrade the Docking Station firmware via USBDevice and System values Upgrading the Docking Station Firmware Page It’s Your World Take Control