Installing the MVP-WDS-SK Silver Conversion Kit
The
One Silver Cradle Bezel/Faceplate
One Silver Cradle Pivot (Support Cradle)
One Silver Battery Cover
One securing rare earth magnet
One securing magnet cup
One
Two plastic Die Cut Foam covers
Installation of the kit involves four different sets of procedures:
Removing the original faceplate.
Removing the original pivot unit (consisting of the battery cover and support cradle).
Installing the new conversion kit’s pivot unit components.
Installing the new silver faceplate.
When installing the
The Conversion Kit cannot be installed while the WDS in a wall or conduit box. If the WDS is mounted, remove ot before continuing.
Removing the original faceplate
1.Remove the previously installed
2.Carefully remove the previously adhered Die Cut Foam covers from the WDS backplate (FIG. 18). These must be removed to gain access to the two
3.Place the back of the
4.Connect the 3.5 mm
Static electricity can damage electronic circuitry. Before touching the unit, discharge any accumulated static electricity from your body by touching a grounded metal object.
5.Open the Battery Compartment by pressing down on the Battery Compartment Latch and pulling the cover outwards.
6.Press the Cradle Activation pushbutton (FIG. 18) to make the MVP Support Cradle rise upwards. The MVP Support Cradle must be angled upward to allow removal of the faceplate.
18 |