AMX MVP-WDS manual Faceplate securing latches

Page 26

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box

Faceplate securing latches

Faceplate

FIG. 20 Faceplate removal from MVP-WDS

As you are removing the faceplate, you will have to press down on the Security Latch to allow a complete removal of the faceplate.

14.Press downward on the Security Latch (towards the pushbutton) to get it to go through the top opening and allow the faceplate’s removal.

15.Grab the top rim of the faceplate and carefully slide it over the cradle (at an angle) until the faceplate is completely removed from the MVP-WDS.

Removing the existing black pivot unit (battery and cradle combo)

1.Unscrew the two MVP Support Cradle Securing screws, located on the lower right side of the unit (just above the USB connectors) (FIG. 21) and set them aside.

MVP Support Cradle

Securing screws (2)

FIG. 21 Removing the MVP Support Cradle securing screws

2.Insert the screwdriver into the large hole on the side of the existing black WDS housing (FIG. 21).

3.Position the unit to allow a clear view through the gap between the cradle and the rim of the metallic WDS housing (FIG. 22). This view allows you to orient the alignment between the tip of the screwdriver and the screw holding the support cradle to its associated movement mechanism.

20

MVP-WDS Wall Docking Station for MVP Panels

Image 26
Contents MVP-WDS AMX Limited Warranty and Disclaimer FCC Information Page Table of Contents Page MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box OverviewSpecifications MVP-WDS SpecificationsMVP-WDS docking station connector locations LED IndicatorsInstallation Installing the CB-MVPWDS Conduit BoxRemoving the MVP-WDS Faceplate MVP Support CradleSecurity Latch Faceplate Securing Latches Faceplate Connectors Installing the MVP-WDS in a CB-MVPWDS Conduit Box Installing the MVP-WDS Using Expansion Clips MVP-WDS Wall Mount cutout dimensions using expansion clips Replacement drywall clip sets cab be ordered from AMX Screws not included Replacing the Faceplate on the MVP-WDS Connecting a Power SupplyPowering the MVP-WDS Using the 3.5mm mini-Phoenix Connector for Power Connecting and Using USB Input Devices on the StationsInterface Connector Pins and Functions Securing an MVP Panel to an MVP-WDSSecured MVP removal from an MVP-WDS Removing an MVP Panel from an MVP-WDSUnsecured MVP removal from an MVP-WDS Undock-USER String Installing and Charging Batteries in the Docking StationsInstalling MVP-BP Batteries Into the MVP-WDS Installing the MVP-WDS-SK Silver Conversion Kit Removing the original faceplateSecurity Latch Faceplate securing latches Gap opening Installing the new conversion kit’s pivot unit components Removing the attached circuit boards a & BInstalling the new silver faceplate Installation of silver cradle pivot and battery coverMVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box Upgrading the Docking Station Firmware Prepare the Docking Station for firmware transfer via USBUpgrade the Docking Station firmware via USB Default Modero panel value isDevice and System values Upgrading the Docking Station Firmware Page It’s Your World Take Control