Troubleshooting guide
The following checklist will assist in the correction of most problems you may encounter with your unit.
Before going through the checklist below, refer to the operating procedures.
General
Problem | Cause/Solution |
No sound. | ∙ Adjust the volume with (+). |
| ∙ Set the fader control to the center position for |
| systems. |
|
|
No beep tone. | The beep tone is muted. |
|
|
Tape playback
| Problem | Cause/Solution |
| Playback sound is distorted. | Contamination of the tape head. nClean the head. |
|
|
|
| The AMS does not operate | ∙ There is noise in the space between tracks. |
| correctly. | ∙ A blank space is too short (less than four seconds). |
EN | ∙ + on (SEEK/AMS) is pressed immediately before the | |
|
| following track. |
|
| ∙ =on (SEEK/AMS) is pressed immediately after the track |
|
| starts. |
|
| ∙ A long pause, or a passage of low frequencies or very low |
|
| sound level is treated as a blank space. |
|
|
|
| Radio reception |
|
| Problem | Cause/Solution |
|
|
|
| Preset tuning is not possible. | ∙ Store the correct frequency. |
|
| ∙ The broadcast is too weak. |
|
|
|
| Automatic tuning is not possible. | The broadcast is too weak. nUse manual tuning. |
|
|
|
If the
12
Actual total number: | Sony |