Lucent Technologies Transtalk 9000 manual Installing a Single Carrier on a Shelf or Desk

Installing a Single Carrier on a Shelf or Desk

■You will not receive optimum performance if unit is placed on a desk or low shelf

■Install as high as possible, leaving 6–12 inches (15.2–30.5 cm) between antennas and ceiling if on high shelf

■Never install or remove a radio module from a carrier that is plugged into a wall outlet (hot insertion)

■See “Key Components” earlier in this chapter for additional picture detail

1Perform the tests described in "Wireless Test Mode" earlier in this chapter to determine the

optimal placement of the radio module. To perform the tests, all you need is an electrical outlet for the radio module and a charged battery pack in the handset.

2

Check to make sure the carrier’s power cord is unplugged from the wall outlet before continuing.

3Remove the plastic cap covering each radio module’s card edge before installing the radio

modules in the carrier.

4Starting from the leftmost slot (#1), insert each radio module into the carrier by hooking it onto

the radio module mounting rod. Slowly swing the radio module's card edge into the card edge connector on the back of the carrier.

2-18Installing the MDW 9030P Pocketphone