Lucent Technologies Transtalk 9000 manual Carrier, doing so causes all handsets to work

6

Connect an expansion cable to the OUT jack of the control carrier.

CAUTION
		IN
		OUT
		YNC
OUT	OF	S

7Insert the free end of the expansion cable into the IN jack of the expansion carrier immedi-

ately to the right of the control carrier.

CAUTION

NOTE:
Although installing an expansion cable				IN
into the wrong IN or OUT jack will not harm either			OUT
carrier, doing so causes all handsets to work
			YNC
improperly and the Out of Sync LED to light.	OUT	OF	S

8If you have a second expansion carrier:

a.Connect an expansion cable to the OUT jack of expansion carrier #1.

b.Insert the free end of the expansion cable into the IN jack of expansion carrier #2.

See “Key Components” earlier in this chapter for an illustration of a three-carrier setup.

9Remove the plastic cap covering each radio module’s card edge before inserting the radio

modules into the carriers.

From

Control

Carrier

Installing the MDW 9030P Pocketphone 2-25