Lucent Technologies Transtalk 9000 manual Installing Multiple Carriers

Installing Multiple Carriers

■Install each carrier high on wall, leaving 6–12 inches (15.2–30.5 cm) between antennas and ceiling

■Install each carrier 1 foot (0.3 m) optimal to 4 feet (1.2 m) from its neighboring carrier

■Never install or remove a radio module from a carrier that is plugged into a wall outlet (hot insertion)

■See “Key Components” earlier in this chapter for additional picture detail

1Perform the tests described in "Wireless Test Mode" earlier in this chapter to determine the

optimal placement of the radio module. To perform the tests, all you need is an electrical outlet for the radio module and a charged battery pack in the handset.

2

Check to make sure the carrier’s power cord is unplugged from the wall outlet before continuing.

3Choose a location backed by a wooden stud for the carrier (if unavailable, use toggle bolts

instead of the supplied wood screws).

IMPORTANT:

The leftmost carrier must be the control carrier. See "Setting the Control/Expansion DIP Switch" earlier in this chapter.

Place the carrier against the wall, leaving enough room to the right for additional carrier(s) if applicable. Hold the carrier straight; use a level if needed. Using a nail or pencil, mark screw locations through the four wall-mount holes. Start the screws, leaving the screw heads protruding approximately 1/2" (12 mm) from the wall.

4Repeat Steps 1 through 3 for each carrier.

Place the carrier over the screws, then slide it

5downward to lock it into place. Be sure that the leftmost carrier is the control carrier. Tighten the screws. Repeat for each carrier.

4 TRANSTALK

CAUTION
	IN
	OUT
OUTOF	SYNC

1 2 3 4 5 6

2-24Installing the MDW 9030P Pocketphone