7Verify that the carrier’s Out of Sync LED is not lit. If the LED is lit, power down and then
repower the carrier. If the LED is still lit, follow the suggestions in the "Installation Problems" section of Chapter 5, "Troubleshooting." If the LED is still lit, call for help as described on the inside front cover of this book.
8Reprogram any handset features and settings that reverted to the default settings when the
system was powered down (see "Changing the Handset Settings" in Chapter 3).
|
| OUT |
|
| YNC |
OUT | OF | S |
| ||
|
| |
4 |
|
|
Swapping Extensions
If you want to change your phone’s extension number assignment, make sure the radio module or carrier(s) is unplugged before you unplug the telephone line cord from the communications system switch/control unit. Power down and then repower the carrier(s) after all extension changes are made.
1
Unplug the carrier(s) power cord/AC adapter from the wall outlet.
IMPORTANT:
When power is disconnected from the radio module or carrier, handset features and settings are reset to the factory default settings.
2Unplug the telephone line cords from the communications system switch/control unit for
the extensions that you want to change.
N | X |
|
S | T |
|
I | E |
|
O | N |
|
N | S |
|
S | I | MUSIC |
| O | |
|
| ON |
| N | HOLD |
| S |
|
3Insert the telephone line cords for the exten- sions that you want to change into the desired
extension jack or terminal/station connector on your communications system switch/control unit.