Lucent Technologies Transtalk 9000 manual Using Wireless Test Mode

Using Wireless Test Mode

You can determine sound clarity, signal strength, and voice quality using Wireless Test Mode. You can also use Wireless Test Mode to identify which radio module matches your handset.

NOTE:

Ignore anything that displays if you press 4or 5while in Wireless Test Mode. These displays are for Lucent Technologies technicians’ use only.

To identify the matching radio module for your handset, use the following procedure:

1.Make sure the handset is turned off.

2.Press and hold the Select button (") for three seconds.

3.While still holding ", press O.

The handset beeps twice, and the display shows the handset settings, indicating you are in Local Mode. (While in Local Mode, the MDW 9030P can still receive notification of incoming calls.)

4.Press "W" (9) to enter Wireless Test Mode.

WIRELESS TEST appears on the top line of the handset display. The handset beeps twice and vibrates, then you hear a simulated dial tone. This dial tone continues until you exit Wireless Test Mode. While in this mode, the MDW 9030P cannot make or receive calls.

5.To identify the matching radio module for this handset, press 3.

The display indicates in which slot in the individual carrier (SLOT:n) the matching radio module is located, using a number (n) from 1 to 6 . A stand-alone radio module is shown as 0. For example:

ON

6. To exit Wireless Test Mode and Local Mode, press O.

Using the MDW 9030P Pocketphone 3-13