Lucent Technologies Transtalk 9000 manual Radio Modules and Carriers

Radio Modules and Carriers

This section explains how to install radio modules and carriers. You should proceed through this section in the following order:

1.“Key Components”

2.“Positioning a Single Radio Module or Carrier(s)”

3."Wireless Test Mode"

4.Choose one of the following paths, depending upon which components you are install- ing:

■ If you are installing a single radio module, go to “Installing a Single Radio Module.”

■If you are installing a single carrier (from two to six radio modules), go to “Setting the Power Level.” Then go to either:

–“Installing a Single Carrier on a Shelf or Desk” or

–“Installing a Single Carrier on a Wall”

■If you are installing multiple (up to three) carriers (from 7 to 18 radio modules), go to all of the following, in order:

a.“Setting the Power Level,” then

b.“Setting the Control/Expansion DIP Switch,” then

c.“Installing Multiple Carriers.”

5.“Installation Self-Test”

NOTE:

The illustrations in this chapter depict PARTNER system hardware; your hardware may differ from these illustrations.

2-6Installing the MDW 9030P Pocketphone